Quote:
Originally Posted by globalrex
Ok so i am an idiot and was swapping my turbo when i dropped a bolt into the the open hole of the transmission. right now the car's jacked up and im slowly getting to the point where im ready to drop the tranny. however, i have run into a little problem. the hex plug that allows you the thread the bolt into and pull the cylinder out will not budge. any suggestions? (do you just pull it out or do you use a bolt and wrench to break the seal) Any input would be cool because im loosing my head over this one[IMG]file:///C:/DOCUME%7E1/MAXR%7E1.LAN/LOCALS%7E1/Temp/moz-screenshot.jpg[/IMG]
|
first off u MUST find the bolt that fell into your tranny
, sounds like bad news. second put the 10 mm allen wrench in the plug and put a long box end wrench on the allen wrench and use it like a breaker bar. don't forget to curse at it in japanese, it only understands how a japanese man would speak to it. no speeky english yo
i should have mine finished tomorrow