Here's the deal: these are the flaps as I found on a Japanese Impreza site... the fronts ARE different than the ones I've seen at Challenger Deep and the like, but I actually think these will fit better. The rears are identical to what I've seen. I made the orginal templates in cardboard from (honestly) VERY painstaking measurements and a lot of math from a photo of these 'new' STi flaps (the pics were NOT straight on unfortuanately, hence all the math). I then made them in PSP yes, using all the measurements off of the templates against the rulers in PSP. I actually am going to add the holes as soon as I have a few moments.... The pics have WAY too many holes in the flaps, and I'm not sure why. I want to get the templates out to the car and figure out where the holes should be. I got my material from Susquehanna today, so I'll have pics soon. As for the hardware... that won't be so easy! It's been a LONG time since I did any metalwork.....