View Single Post
Old 08-11-2009, 09:27 PM   #15
bugeyesubie
Scooby Specialist
 
Member#: 179783
Join Date: May 2008
Chapter/Region: W. Canada
Location: Calgary
Vehicle:
2002 WRX
Silver STi swap 380wph!!

Default

hey i just bought a bare ej22t block and am starting to decide what parts to use for my short block. could i get some details on your short block, what rod, crank, pistons (and size) and bearings are you using. The forged 79mm crank where is that from. which bearings did you use since the thrust is in the middle and not on the end and how much clearance did you run. i will be bolting my block up to cosworth big valve heads.
thanks in advance. good luck !
* Registered users of the site do not see these ads.
bugeyesubie is offline   Reply With Quote