View Single Post
Old 08-31-2007, 06:21 PM   #10
LiquidForce
Scooby Specialist
 
Member#: 12811
Join Date: Nov 2001
Chapter/Region: South East
Location: Roswell Ga
Vehicle:
2002 2.5l Wrx
517whp/516wtq (Stage pi)

Default

Quote:
Originally Posted by THEVERGE View Post
Sorry to butt in here, but I am currently building an 02 motor and havent installed the cams yet.

What do you mean by the torque values are wrong for the cam caps? What will happen? where can i get the right ones?

Also will i run into problems using the older headbolt specs?

Thanks
I snapped one of the cam cap bolts. The manual says 14 ftlbs for the front and 14 for the ones under the valve cover. The ones on the front (outside the valve cover) should only be 7 ft lbs.


I never had an issue with the headbolts using the old routine but I am certain Subabru revised it for a reason.
* Registered users of the site do not see these ads.
LiquidForce is offline   Reply With Quote