|07-02-2006, 09:30 PM||#1|
Join Date: Jan 2006
Unable to reflash base map
Im not sure if this is a problem anyone else has encountered, but I hope so because I need some suggestions.
In february I purchased a new accessport, and flashed to stage one. The cable that came with my a.p. wouldnt power the unit, so the vendor sent me a new cable. I tried it briefly, and saw that it powered the a.p. just fine. I had borrowed a friends cable so I had already been able to reflash to stage one. (in other words, I have yet to get a successful reflash out of my new cable)
After installing a new exhaust today, I tried to reflash to stage 2. The green and white clips are both in place. After an hour of trying I am still getting the same message, "initializing ecu", followed by "turn key off completely, and turn back on". I cant get it past this step. I have read the instructions twice today, and double checked things but still no clue.
Here are my guesses:
Another bad cable?
some sort of interference from my aftermarket alarm?
other than that, I am at a loss. I Hope this is something I have simply overlooked. Any help is appreciated.
Last edited by BenWeavdog; 07-02-2006 at 09:50 PM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Reflashed base map, need to reset ECU?||SWRX||AccessPort||1||09-27-2006 08:55 PM|
|Wierd idle with a freshly reflashed base map||gozway||AccessPort||0||07-12-2006 12:19 AM|
|how long does it take for you to change base maps with AP?||intence||Engine Management & Tuning||7||01-06-2006 07:19 PM|
|Accessport: unable to change realtime maps for 02 wrx||sadd16||Engine Management & Tuning||12||09-30-2005 12:54 PM|
|Any bad exp. with ECU reflash base maps?||ChrisF||Engine Management & Tuning||4||05-03-2003 04:14 AM|