Originally Posted by Matth3w
I was wondering if the OP can update this trick in the first post since it seems to be a bit of a frequently asked question (and as of page 8 I havent seen a really good answer):
When you are putting your IC pipes on and before you clamp them down, coat the pipe and the inside of the rubber withn aresol hairspray. This is the trick I used when I was putting together both of my turbo kits on my Mazda. The hairspray lubes it up but when it dries creates an excellant seal. When I took my turbo kit apart I had to damn near put the **** in a vice to get it off, and never once had IC piping pop off.
BTW I'm running this FMIC on a OTS txs map and a vf39 with no problems at all.