|06-07-2008, 07:30 PM||#1|
Join Date: Mar 2007
HIGH+LOW on after Foglight mod, no fog lights (HELP?)
I followed the procedure as outlined and it worked correctly, but as I was closing things up after testing i snagged the RED-Green wire (the harness/cut that was 'left' as from the back of the relay).
NOW, after the snag ofo the RG wire... I'm getting:
1) as modified:
-- Orange tapped, connected to R/G on relay
-- R/G on switch spliced to R/G on relay (essentially, connected to orange)
-- YG on switch attached to ground
-- RG and YG from the harness end of the switch were capped and left disconnected
--> Headlights work, DRLs work, High beams work.
--> Pressing FOG light switch blows 20A fuse under hood, Marker lights turn off.
2) returned to stock:
--> Pressing FOG light switch turns on high-beam filament (low beam filament does not turn off)
... fog lights do not turn on in any condition, always something else happens.
So, I'm just wondering where that red/green wire terminates and what a possible snag could have caused me. ie: if it's grounded, then what.
I'm pulling apart my dash to trace it out .... aaah the mess.
Last edited by segfau|t; 06-07-2008 at 10:31 PM. Reason: clarified behaviour
|Thread||Thread Starter||Forum||Replies||Last Post|
|2004 WRX foglight+plastic around fog lights||b00sted_wrx||Exterior/Styling||2||11-19-2009 08:44 PM|
|Fog light mod - *pop* no fog lights HELP!!!!||scoobbee||Interior & Exterior Modification||6||04-17-2007 08:14 PM|
|WTT NY, LI My WRX OBP foglights for STi fog light covers||absolutexk||Private 'Wanted' Classifieds||7||05-13-2006 12:26 PM|
|Fog light covers where there are no fog lights..||kingtut12||Interior & Exterior Modification||5||01-26-2006 06:22 PM|
|Check Engien light on?? After heave mods...||comcop||General Forum Archive||3||02-06-2001 06:57 AM|