|07-08-2008, 12:27 AM||#1|
Join Date: Sep 2007
2004 WRB STi
Full Race TS, BW 8374 EFR
Supertech valves choices
black nitrided or inconel? standard, .5mm larger or 1mm larger.
Supertech recommends inconel valves for turbo applications. The inconel uses a 751 nickel alloy for high heat. This must be good for nitrous, forced induction applications.
I know black nitride gives the valves a better hardess and also reduces valve guide friction. So this must be for higher reving applications.
Which one? With all the oiling issues I don't know if I want to raise the rev limit. I won't be using nitrous either but it is definitely turbo. I'll have a gt3076r, which would be the best choice.
Will going larger .5 or 1mm valves lose velocity which will inturn lose torque?
My builder recommends doing a 3 angle valve job, any input on this. I've read some like to do a dual radius for less swirl.
Last edited by methaddict; 07-08-2008 at 01:11 AM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|New 1mm over Supertech Valves||Clutch GSX||Engine/Power/Exhaust||2||01-06-2010 05:54 PM|
|Are supertech valves train components any good?||181stLeader||Built Motor Discussion||44||08-28-2009 05:23 PM|
|F/S: Supertech Valves +1mm os. wrx AND sti. Ferrera valves wrx||bugisti||Engine/Power/Exhaust||18||03-11-2009 03:03 AM|
|Best place to get supertech valves??||frayz||Built Motor Discussion||7||09-05-2007 03:23 AM|
|Supertech valves.NEED HELP FAST||brokenarrow||Built Motor Discussion||3||11-28-2006 04:19 PM|