|07-16-2008, 03:05 AM||#1|
Join Date: Sep 2007
2004 WRB STi
OFCD V3, FR TS, BW8374EFR
found a vid of my machinist working on a couple Subaru blocks
I just picked up my block today after a 3 wk wait. I had John Edwards talk to CP Piston's tech support to get the right ra numbers for their rings. Cosworth's tech support also recommended an ra of between 20 or lower for the deck surface to have their head gasket seal correctly. So this was the goal when resurfacing the top of the block deck. John also checked the mains for straightness. The crank was sent out to have a .001" clearance on the rod journals. He also balanced the whole rotational assembly to 1/2 gram.
Here's some vids of machinist I used, John Edwards from Costa Mesa R & D in Orange County, Southern California:
Honing an STI block
YouTube - Subaru STi Block Honing
Here's another vid resurfacing a Subaru SVX block with sleeves:
YouTube - Subaru SVX Sleeved Block Resurfacing
Here's another of his custom 6 qt Subaru oil pan:
YouTube - Subaru Aluminum Oil Pan, etc...
Last edited by methaddict; 07-16-2008 at 03:51 AM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|i just found out one of my old high school friends is an alleged pedophile||cnw||Off-Topic||52||08-24-2008 12:47 PM|
|Found a little vid of my bro, anyway wanted to share.||Hotrodguru||Texas Impreza Club Forum -- TXIC||7||02-13-2006 11:45 AM|
|Cool vid of Stig doing a demo run in an Audi Quattro Group-B car||XenoWolf||Motorsports||13||12-07-2005 04:24 PM|
|found some vid of my old ride WRX Wagon||Boosted Wagon||Member's Car Gallery||8||03-12-2004 03:43 AM|
|A couple of nights ago my girlfriend says, "Why don't we trade my car in for an STi?"||Dorkfish||South West Impreza Club Forum -- SWIC||7||03-13-2003 05:57 PM|