2011-2012 WRX and STi picture thread - Page 403

Dka67 · 10-08-2012, 01:45 PM

Who can hear them over the exhaust anyways?!?!

* Registered users of the site do not see these ads.

0BlueSTi4 · 10-08-2012, 02:17 PM

Quote:

Originally Posted by ryan523

running spacers?

Also wondering this.

Jive Turkey · 10-08-2012, 02:21 PM

i dont think there are any spacers on his car. jes's car is just on coils.

chanomatik · 10-08-2012, 02:28 PM

It looks obvious to me that Jespec is NOT using spacers. Could use 25mm, I think, if they're going to keep the stock wheels.

ChesterWRX · 10-08-2012, 02:28 PM

Quote:

Originally Posted by Dka67

Who can hear them over the exhaust anyways?!?!

i can. i have a wagon if its any different.

the exhaust only drone's mildly IMO.

FLEX'N WRX · 10-08-2012, 02:34 PM

* FS section has details on wheel and brake setup.

wrxineffect2011 · 10-08-2012, 02:42 PM

2013 WRX Limited...finally here. Below: my port installed Fun Meter.

rosedaleny806 · 10-08-2012, 02:59 PM

i have the same spt gauge an mine idles at inbetween 19-20 wtf

ChesterWRX · 10-08-2012, 03:36 PM

Quote:

Originally Posted by wrxineffect2011

2013 WRX Limited...finally here. Below: my port installed Fun Meter.

nice! i have mine and need to throw it on. i got the SMY gauge pod though.

themaus · 10-08-2012, 03:48 PM

Quote:

Originally Posted by rosedaleny806

i have the same spt gauge an mine idles at inbetween 19-20 wtf

Thats normal. The gauge isn't reading in PSI in vacuum.

Improbus · 10-08-2012, 05:08 PM

Well, guy cut a corner too wide in the parking lot and I had to cut the wheel so he didn't hit me and this is how I pay for it.....

I haven't been this angry in a long time. I seriously want to punch holes in stuff right now.

Anyone know if they replacement panel will come with the paint protection stuff on it ? I have 2 of my parts people looking to see if they come painted already.

I found this right side molding painted obsidian black pearl, but it says for the STATION WAGON but from what I can tell the Sedan and Wagon have the same molding. Can any one confirm?

tonymontana1204 · 10-08-2012, 05:16 PM

New Pics

New Video

YouTube (Short URL)

Isoh · 10-08-2012, 05:46 PM

^ nice house.

ricwhic414 · 10-08-2012, 06:21 PM

Quote:

Originally Posted by wrxineffect2011

2013 WRX Limited...finally here. Below: my port installed Fun Meter.

[img]http://farm9.staticflickr.com/8042/8066799185_97b331cfc2_b.jpg[img]

how hard is the install of this and where did you get it?

waltah · 10-08-2012, 06:34 PM

Quote:

Originally Posted by tonymontana1204

New Pics

New Video

http://youtu.be/ev2N1aB8S6I

is this in the adirondack mountains? heading to lake placid tomorrow with the STI

Ghost Rider · 10-08-2012, 07:48 PM

those are the catskills and that house was actually an old rehab center for the rich I believe.

krypton · 10-08-2012, 08:36 PM

Quote:

Originally Posted by Improbus

Well, guy cut a corner too wide in the parking lot and I had to cut the wheel so he didn't hit me and this is how I pay for it.....

I haven't been this angry in a long time. I seriously want to punch holes in stuff right now.

Anyone know if they replacement panel will come with the paint protection stuff on it ? I have 2 of my parts people looking to see if they come painted already.

I found this right side molding painted obsidian black pearl, but it says for the STATION WAGON but from what I can tell the Sedan and Wagon have the same molding. Can any one confirm?

Sorry to see that bro but yes the hatch and the sedan share the same side skirt

besthaticouldo · 10-08-2012, 08:49 PM

Dka67 · 10-08-2012, 08:53 PM

SubieFest?

besthaticouldo · 10-08-2012, 09:00 PM

yea that was subiefest.

patrick10 · 10-08-2012, 09:03 PM

Car looks good man.

Monkeydoco · 10-08-2012, 09:49 PM

Quote:

Originally Posted by Improbus

Well, guy cut a corner too wide in the parking lot and I had to cut the wheel so he didn't hit me and this is how I pay for it.....

I haven't been this angry in a long time. I seriously want to punch holes in stuff right now.

Anyone know if they replacement panel will come with the paint protection stuff on it ? I have 2 of my parts people looking to see if they come painted already.

I found this right side molding painted obsidian black pearl, but it says for the STATION WAGON but from what I can tell the Sedan and Wagon have the same molding. Can any one confirm?

Thanks for that i need a side skirt painted.. I got 1 unpaited , that sh@t came bent and crooked.. Im trying to return it now...

ryan523 · 10-08-2012, 10:43 PM

Quote:

Originally Posted by ricwhic414

how hard is the install of this and where did you get it?

install is as simple as tapping to your place of choice for a 12v power source and running the hose through the firewall and "t"'ing off on the bpv, very easy

BrendanTheGreat408 · 10-08-2012, 11:35 PM

Quote:

Originally Posted by besthaticouldo

Looks like a wrx with sti wheels? looks good!

OneQuiet22 · 10-08-2012, 11:49 PM

Quote:

Originally Posted by ChesterWRX

threw this in today:

front bushings and rear bushing were a royal PITA using ramps... and I didn't have a wrench big enough to yank off the o2 sensor... but oh well.

scrapped my bumper on a steep driveway... so i threw the lip on there yesterday. it appears I'm not alone in that the spacing on these can be a little whacky. i swapped out the bolts and cheap bushing thingies that came with the kit for regular screws.. they are on there tight after drilling pilot holes, gonna throw some nuts and washers on there later.

Are you running 16in steelies? If so how do you like them? And how was the fitment over the calipers? Im about to do the same for a cheap winter setup.

10-08-2012, 05:08 PM	#10061
Improbus Scooby Newbie Member#: 278439 Join Date: Mar 2011 Chapter/Region: Tri-State Location: Pa, USA Vehicle: 2011 WRX Sedan OBP	Well, guy cut a corner too wide in the parking lot and I had to cut the wheel so he didn't hit me and this is how I pay for it..... I haven't been this angry in a long time. I seriously want to punch holes in stuff right now. Anyone know if they replacement panel will come with the paint protection stuff on it ? I have 2 of my parts people looking to see if they come painted already. I found this right side molding painted obsidian black pearl, but it says for the STATION WAGON but from what I can tell the Sedan and Wagon have the same molding. Can any one confirm? Last edited by Improbus; 10-08-2012 at 05:21 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
('11+) 2011-2012 wrx/sti picture thread (for real this time)	guamanian_powered	Impreza Forum	145	11-22-2012 08:14 PM
01-07 wrx and sti drivetrain?	xj bmx	Newbies & FAQs	13	01-26-2012 03:30 PM
('11+) 2011 wrx/sti picture thread (for real this time)	guamanian_powered	Impreza Forum	1	11-16-2011 11:51 PM
Anyone have the 06-07 Impreza WRX and STI master part number and picture list	STEALTH-WRX	Interior & Exterior Modification	0	08-22-2008 02:12 PM
The Official World One STI and SEMA picture thread..	WorldOne	Member's Car Gallery	25	11-29-2003 05:21 PM

10-08-2012, 01:45 PM	#10051
Dka67 Scooby Newbie Member#: 296721 Join Date: Oct 2011 Chapter/Region: SCIC Location: Montebello Vehicle: 11 5door SWP	Who can hear them over the exhaust anyways?!?! * Registered users of the site do not see these ads.

10-08-2012, 02:21 PM	#10053
Jive Turkey Scooby Guru Member#: 219492 Join Date: Aug 2009 Chapter/Region: Tri-State Location: Soviet Russia Vehicle: 11' STi, RIP CSK. 13' Galaxy Blue Breeze	i dont think there are any spacers on his car. jes's car is just on coils.

10-08-2012, 02:28 PM	#10054
chanomatik NASIOC Supporter Member#: 159474 Join Date: Sep 2007 Chapter/Region: AKIC Location: East Anchorage (yuck!) Vehicle: 2013 BRZ Ltd 6MT CBS Counter-steer like a boss	It looks obvious to me that Jespec is NOT using spacers. Could use 25mm, I think, if they're going to keep the stock wheels.

10-08-2012, 02:34 PM	#10056
FLEX'N WRX NASIOC Supporter Member#: 163672 Join Date: Nov 2007 Location: Where the sidewalk ends... Vehicle: GV Same color as veneers	* FS section has details on wheel and brake setup.

10-08-2012, 02:42 PM	#10057
wrxineffect2011 Scooby Newbie Member#: 265035 Join Date: Nov 2010 Chapter/Region: MWSOC Vehicle: 2013 WRX Limited DGM	2013 WRX Limited...finally here. Below: my port installed Fun Meter.

10-08-2012, 02:59 PM	#10058
rosedaleny806 Scooby Specialist Member#: 202070 Join Date: Feb 2009 Chapter/Region: Tri-State Location: Queens, NYC/East Meadow, NY Vehicle: 2012 WRX Prem. GR WR Blue	i have the same spt gauge an mine idles at inbetween 19-20 wtf

10-08-2012, 05:46 PM	#10063
Isoh Scooby Specialist Member#: 292691 Join Date: Aug 2011 Chapter/Region: SCIC Location: Los Angeles, California Vehicle: 2012 WRX World Rally Blue	^ nice house.

10-08-2012, 07:48 PM	#10066
Ghost Rider Scooby Specialist Member#: 70346 Join Date: Sep 2004 Chapter/Region: Tri-State Location: NY Vehicle: 2011 WRX Lightning Red	those are the catskills and that house was actually an old rehab center for the rich I believe.

10-08-2012, 08:49 PM	#10068
besthaticouldo NASIOC Supporter Member#: 279660 Join Date: Apr 2011 Chapter/Region: MWSOC Location: STL Vehicle: LOL Celery sits down to pee

10-08-2012, 08:53 PM	#10069
Dka67 Scooby Newbie Member#: 296721 Join Date: Oct 2011 Chapter/Region: SCIC Location: Montebello Vehicle: 11 5door SWP	SubieFest?

10-08-2012, 09:00 PM	#10070
besthaticouldo NASIOC Supporter Member#: 279660 Join Date: Apr 2011 Chapter/Region: MWSOC Location: STL Vehicle: LOL Celery sits down to pee	yea that was subiefest.

10-08-2012, 09:03 PM	#10071
patrick10 Scooby Newbie Member#: 234145 Join Date: Jan 2010 Chapter/Region: South East Location: Eastern, NC Vehicle: 2012 SWP STi	Car looks good man.