|02-27-2005, 04:15 PM||#1|
Join Date: Jun 2003
Location: Houston, TX (sugarland, TX)Vehicle:
2002 ej257 Black WRX
How do you tune with a cutout with a utec?
utec w/ tuna
TBE to stock muffler
GT Spec gen II header + uppipe
Normally i would tune my car with my exhaust how it is, with the 3" HKS downpipe to my home made 3" midsection to stock muffler. I used to have an electrical cutout by QTP but the thing always leaked and broke on me 2 months later. I still have an extension that comes out of my downpipe (like maybe 4" or 3" long at the most), but it has a plate that covers it. went to the track the other week and i decided to take the plate off and see the results. I gained 2 mph on my trap . Put the plate back on in less than 5 minutes (3 bolts) and then drove home in quiet.
So today i took off the plate just for fun and i noticed that the AFRs on my Tuna were ridiculous high. For instance, at idle, my AFRs were from lowest to highest 16 - 18.
I know the reason is because the o2 sensor is right where the cutout is, but, i was just wondering how would one tune with a cutout?
Here are some pics:
Last edited by jefersun; 02-27-2005 at 04:22 PM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How do you tune out boost creep with Utec?||scooby24||Engine Management & Tuning||23||03-24-2005 11:51 AM|
|How do you tune a turbo using an EGT?||Homemade WRX||Engine Management & Tuning||10||04-10-2003 08:47 PM|
|How do you tune a BOV? (APS 50/50)||rlavalle||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||18||01-22-2003 07:25 PM|
|How DO YOU tune a Unichip??||black99gt||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||11||11-28-2001 03:33 PM|
|How do you tune a car for lower bottom end torque?||Superu||Normally Aspirated Powertrain||0||09-02-2001 09:30 PM|