|
|
|
|
Thread Tools | Display Modes |
09-26-2006, 01:35 AM | #1 |
Scooby Specialist
Member#: 90235
Join Date: Jun 2005
Chapter/Region:
SCIC
Location: Valencia
Vehicle:1993 GC ej255 swap White |
Adjusting gas pedal
I've been looking around on how to adjust the gas pedal on a 93L.. but found nothing so does anyone have any suggestions for me? Its really hard for me to heel toe cause the gas pedal is so low to the floor... Is there a way ?? any suggestions help thanks
thanks Ray
* Registered users of the site do not see these ads.
|
09-26-2006, 02:15 PM | #2 |
Scooby Specialist
Member#: 123375
Join Date: Aug 2006
Chapter/Region:
Tri-State
Location: N. New Jersey
Vehicle:1997 Impreza OBS Green and gold |
You can adjust how tight the cable is for better repsonse, but i dont think theres anyway to adjust how it sits. You can screw some kinda rubber block onto the pedal to change where your foot contacts it. Just use whatever thickness you need and cut to shape.
|
09-26-2006, 10:05 PM | #3 |
Scooby Guru
Member#: 6486
Join Date: May 2001
Chapter/Region:
MWSOC
Location: S.E. wisconsin
Vehicle:00 Impreza 2.5 RS Blue Ridge Pearl |
Look up under the dash and figure out where the gas pedal is mounted and shim it out with washers or the like. If that can't be done then bend it.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Adjusting Gas pedal | HighRevimpreza | Brakes, Steering & Suspension | 2 | 09-26-2006 02:24 AM |
gas pedal adjustment | Migo | Normally Aspirated Powertrain | 4 | 04-12-2006 03:08 PM |
Gas pedal adjustment? Don't like the pivoting... | Brian Broz | Newbies & FAQs | 0 | 05-04-2005 11:13 AM |
Anybody make a gas pedal (heel/toe friendly) that matches our oe pedals? | BIGSKYWRX | Interior & Exterior Modification | 12 | 09-09-2003 03:09 PM |
Gas pedal "hardness" adjustment | DarthChicken | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 7 | 04-30-2002 01:14 AM |