|
|
|
|
Thread Tools | Display Modes |
08-27-2005, 12:53 AM | #1 |
Scooby Specialist
Member#: 87194
Join Date: May 2005
Chapter/Region:
MAIC
Location: Herndon, VA
|
I just installed a boost gauge and I have a boost question...
I installed a factory boost gauge on my steering column (lamco) and had some questions.
It looks like my max boost is .08-.09 bar. Is this correct for a stock wrx? After it hits .08-.09 bar, it stays there for a second then drops to .06-.07 bar above 4000 rpm. Is this normal? I tightened and zip tied the vacuum lines as good as I could to the T fitting near the fuel pressure regulator. They lines weren't an extremely tight fit over the T fitting, but were somewhat snug... Thanks, Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Just installed boost gauge and EGT have some questions | 04bluedubRex | North West Impreza Club Forum -- NWIC | 21 | 02-06-2009 11:07 AM |
Just Installed the OEM Lamco Boost Gauge and Now I Have an Issue with the STi... | Red Rexx | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 28 | 07-28-2008 10:04 PM |
know anyone around Rowland Height that can install factory boost gauge and have them? | RoC_Pooh | Southern California Impreza Club Forum -- SCIC | 6 | 08-03-2004 06:33 PM |
Just installed my boost gauge and it says my stock wrx is running 20PSI@5k !? | daybreak | Newbies & FAQs | 3 | 10-07-2002 01:20 AM |
New to Turbos and I just put in a boost gauge, now I have a question | gotsol | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 6 | 07-09-2002 08:33 AM |