|
Brakes & Suspension Forum sponsored by The Tire Rack |
|
|
|
Thread Tools | Display Modes |
12-10-2023, 05:21 PM | #1 |
Scooby Newbie
Member#: 533869
Join Date: Apr 2023
|
Am I retarded?
Someone tell me what’s going on. I just replaced multiple parts on my 05 WRX no issue and when I got to my control arm bushings they don’t seem to line up anymore? The bushings I’m using are “Energy Suspension” Polly bushings. Even with OEM rubber washers it doesn’t make a difference
Any help? https://imgur.com/a/A0AA1IV
* Registered users of the site do not see these ads.
|
12-11-2023, 03:18 PM | #2 |
Scooby Guru
Member#: 107618
Join Date: Feb 2006
Chapter/Region:
Tri-State
Location: NY
Vehicle:06 GG WRX / 09 FXT @florencedestinedfxt |
Depends on what else you replaced as well but it doesn't seem too far off. I would remove the knuckle off the control arm, loosely tighten the front and rear bushings and then put the knuckle (and ball joint) back on the arm.
|
Thread Tools | |
Display Modes | |
|
|