|
Brakes & Suspension Forum sponsored by The Tire Rack |
|
|
|
Thread Tools | Display Modes |
02-20-2003, 10:40 PM | #1 |
Scooby Newbie
Member#: 15559
Join Date: Feb 2002
|
Are the sperical bearings on my Perrin end links supposed to be this stiff?
I just got a set of Perrin end links from Teagues, which I won't be able to install until the snow melts. I put a bolt through each of the spherical bearings just to see how stiff the bearings are. The bearings are so stiff that they seem absolutely rigid. Are they supposed to be that stiff?
* Registered users of the site do not see these ads.
|
02-21-2003, 12:41 AM | #2 |
Scooby Specialist
Member#: 12677
Join Date: Nov 2001
Location: Florida
Vehicle:2002 Subaru WRX WR Blue |
Yep
YEP!
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
is my power steering pump supposed to be this loud? | XanRules | Service & Maintenance | 9 | 04-18-2010 01:45 AM |
HELP! is the turbo inlet supposed to be this close to the tgv? | simprezl25 | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 10 | 05-02-2008 11:19 AM |
Are intakes supposed to be this loud? | kaisersouse | Normally Aspirated Powertrain | 27 | 06-27-2005 03:30 PM |
is it supposed to be this hard? | sha_zapple | Off-Topic | 4 | 06-21-2004 12:27 AM |
are brand new wiper blades suppose to be this dirty? | mr_yellow | General Community | 12 | 09-21-2003 10:29 PM |