|
|
|
|
Thread Tools | Display Modes |
06-18-2006, 04:05 PM | #1 |
Scooby Guru
Member#: 43842
Join Date: Sep 2003
Chapter/Region:
Tri-State
Location: NYC
Vehicle:200? WRX STI Aspen White |
Went STG 2 Base map, now i get AIRBAG light
I was temporarly driving with STG 1 Base with STG 2 real time map. Car was runnig good. After reading the map notes and COBB recommending to run STG 2 BASE i did so. Everything runs fine, hits target boost. But as im driving the airbag light comes on on the cluster....
It doesnt go away unless i shut the car off and re-start it. Then it comes back on again. Sometimes after couple minutes of driving or something right away....what could it be??? thank you for the help |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bullwinkle stg 2 base logs | BriGuy375 | Open Source Reflashes | 1 | 03-05-2009 03:54 PM |
XTM map upgrade from cobb stage 2 base map?? | hella_sti | AccessPort | 0 | 03-26-2008 10:36 AM |
Just went Stg 2, now flashing CEL | richde | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 10 | 12-03-2005 10:38 AM |
Loaded TXS Stage 2 base map, now what to do? | jefersun | Engine Management & Tuning | 4 | 07-15-2004 05:08 PM |
Stg 2 base map == knocking HARD | jpmarotta | Engine Management & Tuning | 12 | 04-09-2003 01:49 PM |