|
|
|
|
Thread Tools | Display Modes |
01-26-2008, 11:58 AM | #1 |
Scooby Newbie
Member#: 91210
Join Date: Jul 2005
Chapter/Region:
BAIC
Location: SSF
Vehicle:2004 WRx Black |
Idling problems and wierd Cel problem.. Help please
Ok.. so i've been having these wierd idling problems for quite a while now. Im thinking the iacv is messed up, I tried cleaning it a bunch of times, it worked but would **** up again.. So im guessing I need to buy a new one.
But my question is, after the car runs for like 10-15 miles on this messed up idle( like around 1.8k) The check engine like comes on.. But everytime I try to pull the code, my accessport reads no cel's were found? wtf? every single time.. I cant get the code but the check engine light always comes back on?
* Registered users of the site do not see these ads.
Last edited by SPOOLME; 01-26-2008 at 01:15 PM. |
01-26-2008, 12:36 PM | #2 |
Scooby Specialist
Member#: 119532
Join Date: Jul 2006
Vehicle:2006 WRX |
your ap isnt a code reader
|
01-26-2008, 01:15 PM | #3 |
Scooby Newbie
Member#: 91210
Join Date: Jul 2005
Chapter/Region:
BAIC
Location: SSF
Vehicle:2004 WRx Black |
|
01-26-2008, 01:51 PM | #4 |
Scooby Newbie
Member#: 156727
Join Date: Aug 2007
|
The AP should be able to pull the code, I always use it to pull codes. I had a idle problem for a while with a cell, turned out to be my intake. I only started having the problem after i cleaned my MAF, which was weird. I had the short ram on for 50k+ without a problem, until i cleaned the MAF. Do you have a aftermarket intake? Try swapping back to the stock intake if you have an aftermarket. It worked for me.
|
01-26-2008, 02:07 PM | #5 |
Trust no one
Moderator Member#: 11170
Join Date: Oct 2001
Chapter/Region:
Tri-State
Location: NYC
Vehicle:02 RAV4 MT 15 WRX/11 CRZ |
The AP can read some codes, but it is NOT an OBDII device so it does not accurately report all codes.
Get the car scanned with a proper OBDII scanner at Autozone, a local shop, dealer, or by another member in your area with the right equipment. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problems after downpipe install need help please | The_Black_Pearl | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 8 | 09-12-2007 08:17 PM |
problems with engine? fuel? something? help please. | aznatama | Engine Management & Tuning | 1 | 06-04-2005 05:46 PM |
Help! MAP problems. And a CEL. | Daveish | Normally Aspirated with bolt-on Forced Induction Powertrain | 5 | 12-12-2004 04:17 PM |
Problem after clearing MIL, little help please UTEC | fatray | Engine Management & Tuning | 9 | 08-29-2003 03:12 AM |
('93-'01) problem with a couple lights. Help please! | gimpless | Impreza Forum | 2 | 04-10-2001 02:29 PM |