|
|
|
|
Thread Tools | Display Modes |
09-24-2013, 01:10 AM | #1 |
Scooby Newbie
Member#: 366807
Join Date: Aug 2013
Location: Northern Kentucky
Vehicle:2002 WRX WRB |
Researching for a build
UPDATE: Decided to switch to 2.5L platform.
I've been doing as much research as I can for an upcoming build. Trying to slowly amass the parts I need for my desired goals. I'd like to attempt 350 whp range. (Mustang Dyno in Cincinnati Ohio area) From what I've read this setup should put me in the area. Yes I am familiar with that much power and am sure I want it. Figured I would state that before the "Are you sure you want 400 hp" thread pops up. It's a nice thread and all but I am sure. I plan on running the stock WRX 5spd until it dies. I do understand that if abused the transmission will not think twice about grenading. (Unsure about going with the 6spd or heavier gears. Haven't researched that enough yet. Also would like to drive a 6spd from an STI first.) Let me know if I'm missing something or there's a better route. Feel free to suggest different brands. Currently have: Unknown brand Turboback exhaust. Unknown brand up pipe Cobb AP Engine. Intending to go with a 2.1 stroker setup as what I've seen is the general consensus on hybrids is bad. Looking at this kit. http://www.6starspeed.com/suwrxejpe2st.html May attempt to assemble piece by piece. Hoping to not have to bore. Forged 92 mm Manley Platinum series 2618 alloy pistons from (8.5:1 C.R.) 08+ STI Crankshaft ACL Race series engine bearings Manley Sport Compact H-Beam Rods Valve springs/retainers (suggestions would be nice) Cams - will stock ej205 cams work? Or use STI cams that are modified for non-avcs ARP 11 mm head studs STI oil pump Perrin lightweight crank shaft pulley TGV deletes - will bore out and delete CEL Subaru OEM Gasket kit Crank and rods balanced. Engine honed by shop. Will have the heads gone over by a shop. Belts - suggestions? Spark plugs One step colder - brand suggestions? 1000 CC injectors as I would like to run e85. suggestions? Walbro 255 fuel pump. Big enough? - or DW equivalent as I've been informed they rate their pumps for e85 Blouch 20g xt turbo Grimspeed up pipe and 38mm tial wastegate vented to atmosphere STI TMIC - will that be sufficient? Resurfaced flywheel clutch - will 350 require a stage 1? - brand suggestions? Of course tuned by a reputable shop AFR gauge - Defi gauges suggested - confirm/deny? EGT gauge - Defi gauges suggested - confirm/deny? EBC - suggestions Last edited by Ihaveawagon; 10-02-2013 at 09:55 PM. Reason: Constantly editing |
Thread Tools | |
Display Modes | |
|
|