|
|
|
|
Thread Tools | Display Modes |
08-25-2021, 07:45 PM | #1 |
Scooby Newbie
Member#: 524869
Join Date: Jun 2021
|
WTB ARP Bolts 260-4702 Suggestions?
I have a EJ25 from a 2006 Impreza in a Vanagon. I recently overheated it and I need to replace the head gasket. I believe the proper ARP Studs are the 260-4702. I cannot find any in stock. I ordered some from JEGS with the understanding they would be in next week I was notified that it will be in October. Does anyone have a set? Is there an alternative? I think there may be some 260-4701 around but I think they are too short. My engine is a SOHC
Mark
* Registered users of the site do not see these ads.
|
08-25-2021, 08:06 PM | #2 |
Scooby Specialist
Member#: 508105
Join Date: Nov 2019
Chapter/Region:
NWIC
Location: Greater Seattle Area
Vehicle:Link G4X flex tuned 02' EJ205 20G 6MT wagon |
I would take extra care to make sure you didn't warp the head or the block when it was overheated...
The head-gasket will fail again the same way if its warped and you don't surface it. |
08-25-2021, 11:24 PM | #3 |
Scooby Newbie
Member#: 524869
Join Date: Jun 2021
|
Yes I know. I don't want to take the motor apart until I get the head studs. I will check for warping at that time and make repairs as needed
|
08-26-2021, 11:45 AM | #4 |
Scooby Specialist
Member#: 193940
Join Date: Nov 2008
Location: Philly
Vehicle:2004 WRX STI Black RalliSpec Shortblock |
Why post here and not in the WTB section?
Last edited by BlackFighter; 08-26-2021 at 11:53 AM. |
08-26-2021, 02:47 PM | #5 |
Scooby Newbie
Member#: 524869
Join Date: Jun 2021
|
|
08-26-2021, 04:40 PM | #6 |
Scooby Specialist
Member#: 193940
Join Date: Nov 2008
Location: Philly
Vehicle:2004 WRX STI Black RalliSpec Shortblock |
Call any subaru shop like TiC, Outfront, IAG, RalliSpec, P2P, etc... They should have some in stock
|
08-26-2021, 08:42 PM | #7 |
Scooby Newbie
Member#: 524869
Join Date: Jun 2021
|
|
Thread Tools | |
Display Modes | |
|
|