|
Brakes & Suspension Forum sponsored by The Tire Rack |
|
|
|
Thread Tools | Display Modes |
11-20-2023, 03:51 PM | #1 |
Scooby Newbie
Member#: 527564
Join Date: Nov 2021
Location: Australia
Vehicle:1998 WRX Type R VLim WRC Blue |
Hub & Knuckle interchangeability VA STI to GD STI
Anyone done it?
Ive measured the front and rear hubs and they are identical measurements. Also one site even slipped up and mentioned same part numbers. Knuckles Ive collected a lot of part numbers and I have a theory they are the same (front for sure), rear I have doubts. Why do i want to do this? As I have all the VA stuff but also hope it helps someone as GD STI part prices are through the roof and VA can just buy over the counter.
* Registered users of the site do not see these ads.
|
11-27-2023, 01:29 PM | #2 |
Scooby Specialist
Member#: 297799
Join Date: Oct 2011
Chapter/Region:
South East
Location: Knoxville, TN
Vehicle:2003 WRX EJ207 version 8 |
Front knuckles work, I have a set of GR STI front knuckles on my Bugeye WRX. VA WRX/STI knuckles are the same. ABS might be an issue, but I deleted my ABS long ago. The rear knuckles are a different design. If you want bolt in hubs for the rear knuckles, TSSFab is really the only option.
https://tssfab.us/rear-knuckles/ |
Thread Tools | |
Display Modes | |
|
|