|
|
|
|
Thread Tools | Display Modes |
07-26-2006, 08:09 AM | #1 |
Scooby Newbie
Member#: 114920
Join Date: May 2006
Chapter/Region:
TXIC
Location: Plano, TX
Vehicle:2003 WRX Sedan Silver |
ej20 arias .020 over pistons ring gap
I am just about ready to send my short block out to get it bored for my .020 over arias pistons. When it comes back what should I gap my rings at? I can't seem to find this info.
Also, the standard head gasket is 93mm. Will I need a different head gasket for this new bore size? If I do, do you know where I can get the different size gasket and exactly what size I would need? As you may be able to tell... I have never rebuilt or changed out the internals of an engine before. This is my first time so I appreciate any info/help that can be provided. Thanks, Scooby Rex
* Registered users of the site do not see these ads.
|
07-26-2006, 09:33 AM | #2 |
Scooby Guru
Member#: 32792
Join Date: Feb 2003
Chapter/Region:
NESIC
Location: lincoln, ri
Vehicle:2003 GGA MBP 12.9 / 105+ |
you'd be better off checking the built engine forum.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NA .020 over EJ20 pistons? | gloyale | Normally Aspirated Powertrain | 0 | 10-05-2009 11:44 AM |
JE 2618 Pistons Ring gap & valve notches... | xbcaraudio | Built Motor Discussion | 4 | 04-17-2008 10:23 PM |
ej20 arias .020 over pistons ring gap | Scooby Rex | Built Motor Discussion | 5 | 07-30-2006 11:24 PM |
4-sale Custom CP pistons for 2.2T .020 over | marios03wrx | MAIC Private Classifieds | 8 | 06-18-2006 03:06 PM |
FS: CP forged pistons/rings/pins, 100mm (0.020 overbore for STi EJ257) **NEW** *PICS* | phlegmon | Private 'For Sale' Classifieds | 7 | 06-04-2006 09:55 AM |