|
|
|
|
Thread Tools | Display Modes |
07-02-2012, 07:47 PM | #726 | |
Scooby Specialist
Member#: 283784
Join Date: May 2011
Chapter/Region:
RMIC
Location: Colorado
Vehicle:2015 MUSTANG GT PP GUARD |
Quote:
* Registered users of the site do not see these ads.
|
|
07-02-2012, 07:48 PM | #727 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Yes that is very true. We are having a south Florida meet tomorrow night as well. Should be a pretty good turn out.
|
07-02-2012, 09:53 PM | #728 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Defi red racer 52 mm pressure gauges have been purchased for fuel and oil pressure.
|
07-02-2012, 09:55 PM | #729 |
Scooby Newbie
Member#: 309067
Join Date: Feb 2012
Chapter/Region:
South East
Location: Greensboro, NC
Vehicle:08 WRX STI Dark Grey Metallic |
|
07-02-2012, 10:00 PM | #730 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Yeah I thinking anything I may end up in the future replacing the oil temp gauge with a Defi temp gauge and then moving the AFR gauge somewhere else. I will then put a different Defi gauge in that spot. So then it will be all Defi gauges.
The AFR I will mount somewhere more discrete or just have it so I can plug it in during tunes but then remove it for everyday driving. |
07-02-2012, 10:10 PM | #731 | |
Scooby Specialist
Member#: 283784
Join Date: May 2011
Chapter/Region:
RMIC
Location: Colorado
Vehicle:2015 MUSTANG GT PP GUARD |
Quote:
I love Defi gauges =P |
|
07-02-2012, 10:17 PM | #732 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Yes but when you are doing a pull on the road and need to stare at the AFR gauge I would prefer it be up near the windshield so I can watch the road too.
|
07-07-2012, 04:47 PM | #733 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
July 12''
Kartboy Short Shifter: WRXFTW02 under the car doing the reverse lockout: WRXFTW02 and THEMAUS swapping the shifter: Folks, remember to zip tie the reverse lockout cable from rubbing against the drive shaft when swapping the shift lever!!!! |
07-07-2012, 06:41 PM | #734 |
Scooby Newbie
Member#: 321211
Join Date: May 2012
Chapter/Region:
South East
|
Two things to add to this thread:
#1- Kartboy should really put some type of bright ass warning label indicating to zip tie the reverse lockout cable away from the driveshaft. #2 I was fortunate enough and very thankful that Jockey let me drive his car. I didn't even ask, he just threw his keys at me and said have at at, I thought he was joking. I was like a kid at christmas. This thing pulls like maaddddddd. It's no joke. My stage 2 is a joke compared to this car. |
07-07-2012, 06:58 PM | #735 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Big ups to Themaus and Wrxftw02 for helping out! Actually they did 95% of the work. I provided beverages and great company!
|
07-07-2012, 08:04 PM | #736 |
Scooby Newbie
Member#: 293504
Join Date: Sep 2011
Chapter/Region:
South East
Location: West Palm Beach, FL
Vehicle:2011 WRX Blue |
Ain't no party like an install party. Jock did u finish break in and grab a tune?
|
07-07-2012, 08:11 PM | #737 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
We are in the middle of tuning. I have to do a 4th gear pull. I might have the meth installed prior to actually finishing these tunes.
|
07-07-2012, 10:54 PM | #738 |
Scooby Newbie
Member#: 293504
Join Date: Sep 2011
Chapter/Region:
South East
Location: West Palm Beach, FL
Vehicle:2011 WRX Blue |
So what's your expectations for whp?
|
07-07-2012, 11:08 PM | #739 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Not much different from what it was before. By changing internals to forged it does not change anything for power. The only power adders I did were the TGV deletes. Other than that it was just to strengthen the engine. The real power adder will be when I get the meth installed.
My turbo is limiting me right now plus I am stuck at 93 octane gas. With meth my octane will be much higher and then we can push the timing a bit more. |
07-13-2012, 08:40 PM | #740 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
I've begun the break down of my stock block. Took the oil pan, oil pick up, oil baffle and oil pump off. Started to try to take out the wrist pins but doing it from one side is proving to be difficult. I was going to do the push from one side all the way through trick but the dam block off plates on the clutch side are extremely difficult to get off. I do not have an impact gun and therefore I'm stuck for now.
|
07-16-2012, 05:58 PM | #741 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Finally finished break in with 1,000 miles and my last oil change!
|
07-16-2012, 06:15 PM | #742 |
Scooby Specialist
Member#: 283784
Join Date: May 2011
Chapter/Region:
RMIC
Location: Colorado
Vehicle:2015 MUSTANG GT PP GUARD |
Turnz up ze boost
|
07-16-2012, 06:22 PM | #743 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Tuner wants to wait till we get meth in at the end of the month. I'm sitting at about 20 psi right now.
|
07-16-2012, 07:22 PM | #744 |
Scooby Newbie
Member#: 326301
Join Date: Jul 2012
Location: Cincy,OH
Vehicle:2012 WRX LR - Sold 2015 Forester Premium CBS |
Great build so far man. Subscribed
|
07-16-2012, 07:29 PM | #745 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Thank you
|
07-17-2012, 01:09 AM | #746 |
Scooby Specialist
Member#: 283784
Join Date: May 2011
Chapter/Region:
RMIC
Location: Colorado
Vehicle:2015 MUSTANG GT PP GUARD |
You don't have E85 do you?
|
07-17-2012, 05:34 AM | #747 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
Nope hence meth.
|
07-22-2012, 10:24 PM | #748 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
HT Autos rear diffuser ordered.
A Pillar Triple gauge pod scheduled for delivery tomorrow. |
07-22-2012, 11:32 PM | #749 | |
Scooby Specialist
Member#: 283784
Join Date: May 2011
Chapter/Region:
RMIC
Location: Colorado
Vehicle:2015 MUSTANG GT PP GUARD |
Quote:
|
|
07-23-2012, 05:52 AM | #750 |
Scooby Specialist
Member#: 260868
Join Date: Oct 2010
Chapter/Region:
South East
Location: Lake Worth, Florida
Vehicle:2011 STI White |
It will be here on the 26th. But you can check it out on the HT Autos website. They have the hatchback rear diffuser as well. Unfortunately the sedan version does not cover the entire back.
I already curbed my front lip twice. Once on a wheel stop that was sitting a little higher than usual and then going onto a driveway with a severe break. Sucks but at least my lip was not too expensive. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Will it fit: 2011 STi Sedan exhaust on 2010 WRX Sedan | btr22 | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 42 | 07-08-2016 02:26 PM |
Forged Performance: 2011 STi Sedan MONSTER Build **check back often** | Forged Performance | NASIOC Project Cars | 462 | 07-06-2016 08:06 PM |
Fast Motorsports Prototype 08+ wrx sedan and 2011+ sti sedan catback! first pics! | IMPORTIMAGE | Vendor Announcements | 4 | 05-02-2011 09:50 PM |
Comparing 2011 STi Sedan to 2011 WRX Sedan | DasWRX | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 4 | 12-21-2010 07:09 AM |
new with a question about 2011 STI sedan vs. previous STI sedans | tommygsubie | Newbies & FAQs | 37 | 11-02-2010 12:16 PM |