|
|
|
|
Thread Tools | Display Modes |
04-28-2007, 02:31 AM | #1 |
Scooby Specialist
Member#: 130489
Join Date: Oct 2006
Chapter/Region:
MWSOC
Location: Superior, WI
Vehicle:02 WRX Wagon (WRB) 98 OBS-T, 91 Legacy SS |
Splicing in an E-Manage Ultimate (guide)
I did my write-up on how I spliced in my E-Manage Ultimate.
I posted it in the "Engine Management and Tuning" section since that's really where it belongs. Here is the link... E-Manage Ultimate Install Guide What I did, while written for the E-Manage Ultimate, can easily be done for any engine management system. But in the case of my guide, I included a chart I made specific to the E-Manage Ulitmate with respect to wire colors and such.
* Registered users of the site do not see these ads.
|
04-28-2007, 10:13 AM | #2 |
Scooby Newbie
Member#: 49783
Join Date: Dec 2003
Chapter/Region:
E. Canada
Location: Ancaster, Ontario
Vehicle:2000 2.5rsti&98wagon SRP/white |
sweet, nice write up!
Now I assume that if we just get the wideband o2 sensor and hook it up, when tunning the Emanage software can show you the running A/F ratio correct? So you don't really need a wideband o2 gauge. |
04-28-2007, 03:01 PM | #3 |
Scooby Specialist
Member#: 5030
Join Date: Mar 2001
Chapter/Region:
MAIC
Location: Martinsburg, WV, USA
Vehicle:1999 Legacy 2.5GT 19 Audi RS3, 13 Armada |
I'm assuming thats how it works. I was just planning to run the Innovate LC-1 without a gauge. I'd like to keep as few gauges out in the open as possible.
I was thinking about trying to find some sort of multi gauge display panel. I haven't found much accept for the PSI 3. From what Ive heard though it only displays things that can be read from the OBD-II port. Brad |
04-28-2007, 04:54 PM | #4 |
Scooby Newbie
Member#: 49783
Join Date: Dec 2003
Chapter/Region:
E. Canada
Location: Ancaster, Ontario
Vehicle:2000 2.5rsti&98wagon SRP/white |
well you could go with the PLX 500, it can do A/F, EGT, Knock,etc all on one display. but its liek 500 bucks.
Think i will just go with the simple and cheaper way. |
04-28-2007, 10:01 PM | #5 | |
Scooby Specialist
Member#: 130489
Join Date: Oct 2006
Chapter/Region:
MWSOC
Location: Superior, WI
Vehicle:02 WRX Wagon (WRB) 98 OBS-T, 91 Legacy SS |
Quote:
I was going to just put in a DIN plate below my stereo but then decided that I didn't want to look down to read gauges. The only two gauges I'll be using of signifigance are boost/vacuum and oil pressure. I'm filling the thirs openong with a cheap Equis volt meter. My other two gauges are Autometer cobalts. With the E-Manage keeping the AFR under control I see no need for an AFR gauge. I might do an EGT gauge later on. |
|
04-29-2007, 07:43 PM | #6 |
Scooby Guru
Member#: 36333
Join Date: May 2003
Chapter/Region:
NESIC
Location: East Kingston NH
Vehicle:98 RS GT30R, closed deck madnes |
would this be the exact same on the 98 2.5rs............. rather than outback sport...??? *crosses fingers*
|
04-29-2007, 07:53 PM | #7 |
Scooby Specialist
Member#: 130489
Join Date: Oct 2006
Chapter/Region:
MWSOC
Location: Superior, WI
Vehicle:02 WRX Wagon (WRB) 98 OBS-T, 91 Legacy SS |
|
04-29-2007, 10:32 PM | #8 |
Scooby Guru
Member#: 36333
Join Date: May 2003
Chapter/Region:
NESIC
Location: East Kingston NH
Vehicle:98 RS GT30R, closed deck madnes |
|
04-29-2007, 11:31 PM | #9 |
Scooby Specialist
Member#: 35330
Join Date: Apr 2003
Chapter/Region:
NESIC
Location: Guilford, CT
Vehicle:1999 RSTi + 4.44 = ) Silverthorn... for now |
Thanks for the writeup, now let us know how getting the car running and tuned goes. I have my ultimate all wired up in my 99 RS, but I haven't ran the car yet. I will be sure to post back with any info and advice I can offer.
|
05-01-2007, 02:55 PM | #10 |
Scooby Guru
Member#: 36333
Join Date: May 2003
Chapter/Region:
NESIC
Location: East Kingston NH
Vehicle:98 RS GT30R, closed deck madnes |
^ you run the car yet nic ?
|
05-01-2007, 08:37 PM | #11 |
Scooby Specialist
Member#: 35330
Join Date: Apr 2003
Chapter/Region:
NESIC
Location: Guilford, CT
Vehicle:1999 RSTi + 4.44 = ) Silverthorn... for now |
No, unfortunately I have final exams all week, damn college edumacation... Hopefully this month though.
|
05-01-2007, 10:44 PM | #12 |
Scooby Specialist
Member#: 130489
Join Date: Oct 2006
Chapter/Region:
MWSOC
Location: Superior, WI
Vehicle:02 WRX Wagon (WRB) 98 OBS-T, 91 Legacy SS |
That's also what is delaying my install of just about everything. My last exam is on the 18th. Then I have to do the front brakes on my 77 Cherokee and its time to add a turbo to the scooby
|
03-24-2017, 10:37 PM | #13 | |
Scooby Newbie
Member#: 422344
Join Date: May 2015
Location: Maryland
Vehicle:2015 BRZ |
Chart still floating around?
Quote:
|
|
03-24-2017, 10:39 PM | #14 | |
Scooby Guru
Member#: 36333
Join Date: May 2003
Chapter/Region:
NESIC
Location: East Kingston NH
Vehicle:98 RS GT30R, closed deck madnes |
Quote:
http://www.rs25.com/forums/f145/t208...get-build.html |
|
03-25-2017, 01:37 AM | #15 | |
Scooby Newbie
Member#: 422344
Join Date: May 2015
Location: Maryland
Vehicle:2015 BRZ |
Quote:
|
|
03-25-2017, 02:06 PM | #16 |
Scooby Guru
Member#: 36333
Join Date: May 2003
Chapter/Region:
NESIC
Location: East Kingston NH
Vehicle:98 RS GT30R, closed deck madnes |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to splice in an E-Manage Ultimate | PhilSine | Engine Management & Tuning | 19 | 01-23-2023 12:42 AM |
Anyone install a Greddy E-Manage Ultimate in EJ25 NA car? | GADGTGUY | Normally Aspirated Powertrain | 2 | 10-28-2006 08:10 AM |
E-Manage ULtimate | raymondgo | Engine Management & Tuning | 2 | 08-04-2005 09:57 PM |
e manage Ultimate, closed loop issue with GDA/GDB? | erggy | Engine Management & Tuning | 5 | 07-27-2005 01:32 PM |
e-Manage Ultimate | battousai | Engine Management & Tuning | 17 | 07-10-2005 10:31 PM |