|
|
|
|
Thread Tools | Display Modes |
09-07-2012, 06:44 PM | #1 |
Scooby Newbie
Member#: 219893
Join Date: Aug 2009
Chapter/Region:
NESIC
Location: ct
Vehicle:06 wrx OBP |
updated the firm ware on my ap v2 now the ap won't work details inside plz look
i just put a new turbo and a couple of mods in my 07 wrx. i updated the firmware on my apv2 and loaded a new map on there. when i plug the ap into my car it goes to the first white screen and flashes. if i turn the key to the on position the access port won't even turn on. my car is stuck without this retune and i can't have my car down for very long. anybody run into a problem like this and know any solutions? i called cobb and they suggested maybe a corrupted file on it, other than that ill have to send it to cobb for them to fix it, and i really don't have time to do this.
* Registered users of the site do not see these ads.
|
09-08-2012, 08:34 AM | #2 | |
NASIOC Vendor
Member#: 4803
Join Date: Mar 2001
Location: Austin, TX
|
Quote:
http://www.cobbtuning.com/AccessPORT...rt-s/40200.htm What mods did you install and what map is on the car currently? Depending on what they are, there is a chance that you might be able to drive very conservatively on the current map. If this is not a possibility (say different injectors were installed), you could try to flash a realtime map via the AccessTUNER Race software before you send the AP back, if the map you need is not a locked protuned map. That should be good enough to allow you to drive (also conservatively) until you get your AP back. This may or may not work depending on what the problem with the AP is. Here's link to request a free copy of AccessTUNER Race (for v2 AP users): http://www.cobbtuning.com/accesstune...st-s/70716.htm Bill |
|
Thread Tools | |
Display Modes | |
|
|