|
|
|
|
Thread Tools | Display Modes |
05-04-2019, 09:23 AM | #1 |
Scooby Newbie
Member#: 484302
Join Date: Apr 2018
|
2015-2017 WRX/STI Driver AC Vent Gauge Pod Install
Here is a guide to how I installed an oil pressure gauge. Not alot of options out there for the 15-17 WRX that arent 100 bucks for a piece of plastic. (I think the vents changed in 18 but not sure). This was by far the most economical solution at 25 bucks (gauge pod) that wasnt universal. The only trimming I had to do was on the gauge hardware. If you like the imgur post, beat up the imgur haters (people leaving negative comments on the imgur site for this post) lol.
- Gauge is Innovate MTX-D 3913 Oil. Pressure/Temp 52mm https://www.amazon.com/Innovate-Moto...slXd0fUSZvcMfh - Gauge Pod is Etsy's Driveway Tuning 3D Printed Drivers AC Vent 52mm Gauge Pod https://www.etsy.com/shop/DrivewayTu...g_id=687701659 http://imgur.com/gallery/4or4vd0
* Registered users of the site do not see these ads.
Last edited by J_ODIE; 05-04-2019 at 09:31 AM. |
05-04-2019, 10:39 PM | #2 |
Scooby Newbie
Member#: 482641
Join Date: Feb 2018
Chapter/Region:
Tri-State
Location: Westchester, NY
Vehicle:2015 WRX Dark Grey Metallic |
Huh, weird....I was just wondering about this being a thing like a week ago.
|
Thread Tools | |
Display Modes | |
|
|