|
|
|
|
Thread Tools | Display Modes |
12-06-2011, 05:14 PM | #1 |
Scooby Specialist
Member#: 97904
Join Date: Oct 2005
Chapter/Region:
Tri-State
Vehicle:2002 WRX World Rally Blue |
Hey guys I have an 02 bugeye wrx. i just built a 2.5l race block and added 07 sti heads. My question is, on the 2.0L there was one port over by the turbo but on the 2.5L there is one in the center of the block. I am not using the factory hard line that attaches to the water cooler pipe under the intake manifold. On the 07 valve covers there are 2 ports one larger and one smaller....which 2 will get "T" together and to that pressure port on the back of the block? Any pics or diagrams would be helpful...thanks.
* Registered users of the site do not see these ads.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Assembly: 2.0L Heads on 2.5L block | Kingpin | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 115 | 12-24-2018 06:09 PM |
2.2t heads on 2.5l block | subarumafia700 | Normally Aspirated Powertrain | 19 | 10-07-2011 10:15 PM |
wrx heads on 2.5l block | scott00 | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 6 | 08-13-2007 11:11 PM |
Ported WRX heads and bigger cams on 2.5L block | wrxfactor | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 8 | 05-04-2006 05:35 PM |
Question about MAP sensors and the 2.5L SOHC | subysouth | Normally Aspirated Powertrain | 12 | 11-07-2003 07:01 PM |