|
|
|
|
Thread Tools | Display Modes |
02-05-2014, 04:52 PM | #1 |
Scooby Newbie
Member#: 196920
Join Date: Dec 2008
Chapter/Region:
South East
Location: Paulding County, GA
Vehicle:03 Wrx WRB |
Rear diff blew on interstate now drive shaft doesn't want to turn
Long story short my rear diff broke the cross pin in my r160 and cause the diff to lock up at about 60-65 mph. When it happened I put it in to neutral as fast I could and coasted to the shoulder, because by that time the diff broke apart and freed up. I got a new r160 but when I went to put it in today I realized the drive shaft didn't want to turn by hand like normal then I got in and shifted through the gears with the car off and it no has trouble getting into reverse (all of this is with the car turned off). I even tried to let it roll with the car in neutral and clutch pushed in. It would only move if my brother pushed it, and that's with it sitting on a down hill slope. The car has a 5 speed with PPG 1-4. Help lol any ideas to what it could be? I'm leaning towards the center diff but the reverse situation is throwing me off?
* Registered users of the site do not see these ads.
Last edited by xjustinx; 02-05-2014 at 05:02 PM. |
02-06-2014, 12:38 PM | #2 |
Scooby Newbie
Member#: 380922
Join Date: Feb 2014
|
Sounds like the center diff but could be the trans too
|
02-09-2014, 06:21 PM | #3 |
Scooby Newbie
Member#: 196920
Join Date: Dec 2008
Chapter/Region:
South East
Location: Paulding County, GA
Vehicle:03 Wrx WRB |
|
02-09-2014, 09:27 PM | #4 |
Scooby Specialist
Member#: 127099
Join Date: Sep 2006
Chapter/Region:
BAIC
Vehicle:02 IMPERZA WRX BLACK |
if the rear diff blew the drive shaft will not sping since the gears are broken and will not allow the diff to spin
|
Thread Tools | |
Display Modes | |
|
|