|
|
|
|
Thread Tools | Display Modes |
12-14-2006, 10:43 AM | #1 |
Scooby Newbie
Member#: 49667
Join Date: Dec 2003
Vehicle:2004 WRX 2.5 Hybrid 8cm18G - PPG Helical |
Turbo oil return tube on RHS head?
Does anyone know if there is an O-ring or gasket on this tube that goes to the right-hand side head? Or does it just press in there tight with no kind of seal?
I am pretty sure that this is the oil return tube for the turbo. There is no info about it that I can find in the service manual. It appears that the service manual guy didn't figure it was terribly important.
* Registered users of the site do not see these ads.
|
12-14-2006, 03:54 PM | #2 |
Scooby Newbie
Member#: 49667
Join Date: Dec 2003
Vehicle:2004 WRX 2.5 Hybrid 8cm18G - PPG Helical |
bueller?
|
12-14-2006, 03:56 PM | #3 |
Scooby Specialist
Member#: 112861
Join Date: Apr 2006
Location: VA
Vehicle:2013 STi sedan SWP |
im not 100% sure, but i think there is no gasket for it.
if i remember correctly, it just slides in with the turbo. |
12-15-2006, 03:43 PM | #4 |
Scooby Newbie
Member#: 49667
Join Date: Dec 2003
Vehicle:2004 WRX 2.5 Hybrid 8cm18G - PPG Helical |
I'm actually wondering about on the side that goes into the head. I know that the hose just slides on with a little clamp on the turbo side. I just can't find whether there is any kind of seal on the end that goes into the head. It appears to just swage in there and be held on with that bolt. But who knows.
|
12-15-2006, 04:28 PM | #5 |
Scooby Newbie
Member#: 49667
Join Date: Dec 2003
Vehicle:2004 WRX 2.5 Hybrid 8cm18G - PPG Helical |
I have confirmed that there is no seal on the turbo oil return tube where it presses into the head. In case anyone is curous in the future.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to Remove Turbo Oil Drain Tube on Head? | SEEC | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 10 | 01-09-2024 08:19 PM |
how do you guys remove the oil drain tube on the head? | ownnij | Built Motor Discussion | 14 | 12-10-2009 10:07 PM |
liquid gasket on oil return tube | blackrod punishment | Built Motor Discussion | 9 | 08-20-2009 02:05 AM |
Oil return tube from Turbo | paintbing | Built Motor Discussion | 5 | 04-22-2009 10:35 AM |
Oil return tube to heads | dwx | Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo) | 0 | 09-01-2004 08:30 PM |