|
|
|
|
Thread Tools | Display Modes |
12-13-2006, 01:14 PM | #51 |
Scooby Newbie
Member#: 107118
Join Date: Feb 2006
Vehicle:'02 STi Wagon White |
Richard, the schematic for the PWI-1 indicates the filter (Aquamist pn806257) "below water level," yet its location appears above the tank.
Is this a contradiction or a limitation of the drawing? Jeff
* Registered users of the site do not see these ads.
|
12-13-2006, 03:14 PM | #52 |
Scooby Specialist
Member#: 54935
Join Date: Feb 2004
Chapter/Region:
NWIC
Location: Oregon
|
I mounted the brain or controller in the cab. I have a Forester pocket under my after market stereo. I drilled a couple of holes and ran the wires into there.
|
12-13-2006, 04:45 PM | #53 | |
Former Vendor
Member#: 110029
Join Date: Mar 2006
Location: Sussex, England
Vehicle:2004 Citroen Picasso Silver |
Quote:
Richard Last edited by Aquamist; 12-17-2006 at 12:54 PM. Reason: typo |
|
12-17-2006, 12:51 PM | #54 |
Scooby Specialist
Member#: 22753
Join Date: Aug 2002
Chapter/Region:
South East
Location: East TN
Vehicle:2002 PSM WRX +PPG OBXT |
This is the system I'm looking hard at...have the Spec C trunk tank so the install would be similar...pdx what is your feeling on hours to install this system just as you did? Thanks
|
12-17-2006, 04:08 PM | #55 |
Scooby Specialist
Member#: 54935
Join Date: Feb 2004
Chapter/Region:
NWIC
Location: Oregon
|
Being careful and moving slow, 2-4 depending on your tools and abilities.
|
12-18-2006, 01:52 PM | #56 |
Scooby Specialist
Member#: 53142
Join Date: Jan 2004
Chapter/Region:
SWIC
Location: Las Vegas
Vehicle:06' STI,02WRX,982.5 www.Flat4lv.com |
do you have the pump still in the IC sprayer tank? Just wired it to the main pump control?
|
12-18-2006, 06:12 PM | #57 |
Scooby Newbie
Member#: 89458
Join Date: Jun 2005
Chapter/Region:
South East
Location: Tampa, FL
Vehicle:2006 Superzilla STi CGM |
So is it okay to mount the pump in this location and use the IC sprayer tank that comes standard on the STI? I thought this had to be mounted below the tank?
Last edited by 41ants; 12-18-2006 at 07:18 PM. |
12-18-2006, 11:25 PM | #58 |
Scooby Specialist
Member#: 54935
Join Date: Feb 2004
Chapter/Region:
NWIC
Location: Oregon
|
As long as you use a primer pump it's OK to mount it above the tank. The Perrin kit has the ability to run a primer pump built in. If you use the factory intercooler spray tank just use the factory pump. If you get a spec C tank like I did it also has it's own pump.
|
05-28-2007, 11:15 AM | #59 |
Scooby Specialist
Member#: 54935
Join Date: Feb 2004
Chapter/Region:
NWIC
Location: Oregon
|
|
06-01-2007, 02:00 AM | #60 |
Scooby Newbie
Member#: 120461
Join Date: Jul 2006
Chapter/Region:
PRSIC
Location: Philippines
Vehicle:Davi WRX STi JBP DavidAgorsAJ |
does anyone have any close ups of the dash display and where they mounted it?
|
06-01-2007, 02:49 PM | #61 |
Scooby Specialist
Member#: 54935
Join Date: Feb 2004
Chapter/Region:
NWIC
Location: Oregon
|
as far as a close up all I have is this preproduction computer drawing.
I posted this already but this is where I mounted it. |
06-02-2007, 05:05 PM | #62 |
Scooby Newbie
Member#: 120461
Join Date: Jul 2006
Chapter/Region:
PRSIC
Location: Philippines
Vehicle:Davi WRX STi JBP DavidAgorsAJ |
thanks a lot, it doesn't look too bad. one question though, is the only protection against running out of meth the led?
|
06-02-2007, 06:37 PM | #63 |
Scooby Specialist
Member#: 54935
Join Date: Feb 2004
Chapter/Region:
NWIC
Location: Oregon
|
no it triggers a fault and shuts off your boost solenoid so you only have waste gate pressure.
|
06-04-2007, 12:02 AM | #64 | |
Scooby Specialist
Member#: 96204
Join Date: Sep 2005
Chapter/Region:
W. Canada
Location: Winnipeg
Vehicle:2013 STI GR White |
Quote:
http://www.legacygt.com/forums/showt...ighlight=pwi-1 |
|
06-04-2007, 07:26 PM | #65 |
Scooby Newbie
Member#: 120461
Join Date: Jul 2006
Chapter/Region:
PRSIC
Location: Philippines
Vehicle:Davi WRX STi JBP DavidAgorsAJ |
^ thanks.. ill definitely check it out.. how are the gains?
|
06-04-2007, 08:32 PM | #66 | |
Scooby Specialist
Member#: 96204
Join Date: Sep 2005
Chapter/Region:
W. Canada
Location: Winnipeg
Vehicle:2013 STI GR White |
Quote:
Gains would be about the same as any alky kit, just maybe a little better then some due to the IDC controlled injection rate. Maybe 35 hp. |
|
06-11-2007, 02:33 PM | #67 |
Scooby Newbie
Member#: 146250
Join Date: Apr 2007
Location: Mauritius
Vehicle:1999 STI type R white |
I have read that the perrin kit can change from 1 to 100 ***37; duty in 10ms. how does it compare with a aquamist 2D hsv reaction speed ? any figures for this last one ?
about that dash display, I have seen silver paint and black unit. what is the latest production color ? |
06-12-2007, 01:46 PM | #68 |
*** Banned ***
Member#: 92467
Join Date: Jul 2005
Chapter/Region:
VIC
Location: https://t.me/pump_upp
Vehicle:08 STI Silver |
couple pics of my setup.
http://sutternow.com/pics/lgt/perrin_wi/index.html However, I need more flow. How much will an accumulator alone add anything to a setup with the 1.0 nozzle? e.g. http://www.urdusa.com/product_info.p...s_id=124806410 Has anyone added an priming pump to this setup?? Anyone have any pics / diagrams? Does anything else need to be purchased besides this--> http://www.urdusa.com/product_info.p..._id=1260198021 Last edited by sutter2k; 06-12-2007 at 02:05 PM. |
06-12-2007, 02:48 PM | #69 | |
Scooby Newbie
Member#: 80744
Join Date: Feb 2005
Chapter/Region:
MAIC
Location: Maryland
Vehicle:2005 Subaru STI Aspen White |
Quote:
Actually, I netted 47.3HP and 43.1TQ, not that a few hp or tq make that much of a diff,but I did pass my 400/400 goal. In case anyone is interested. http://forums.nasioc.com/forums/show....php?t=1264513 A couple interior shots with the new black panel also. |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Perrin PWI-1 Water Injection System | persian prince | Engine/Power/Exhaust | 4 | 10-14-2007 11:34 PM |
Guaging Interest Perrin PWI-1 water injection | pdxsilverwrx | NWIC Private Classifieds | 0 | 09-30-2007 07:38 PM |
Perrin meth/water/alky injection kit BNIB | ImprezvRS | Engine/Power/Exhaust | 5 | 08-20-2007 12:18 AM |
Perrin alchy/water injection kits and Aquamist Kits in stock | Dyno Flash | Engine/Power/Exhaust | 0 | 07-21-2007 09:26 PM |
73.99 Fuel Pumps shipped, Coolingmist Water Injection specials, Turboxs, SBR, Perrin! | IMPORTIMAGE | Engine/Power/Exhaust | 220 | 08-05-2006 01:12 PM |