|
|
|
|
Thread Tools | Display Modes |
09-11-2002, 11:18 PM | #1 |
Scooby Newbie
Member#: 19284
Join Date: May 2002
Location: Vermont
|
how to clean engine bay
what would be the best way to clean out an engine bay?
how can i get it really clean, like showcar clean.
* Registered users of the site do not see these ads.
|
09-12-2002, 08:24 AM | #2 |
Scooby Newbie
Member#: 10461
Join Date: Sep 2001
|
bump
I would like opinions too please. Thanx. |
09-12-2002, 09:06 AM | #3 |
Scooby Specialist
Member#: 19687
Join Date: Jun 2002
Chapter/Region:
MAIC
Location: Baltimore, MD
Vehicle:'02 WRB WRX Non-sedan |
I believe certain places will steam clean the engine. As to where to go to get it done... ???
|
09-12-2002, 10:04 AM | #4 |
GC84Ever
Super Moderator Member#: 301
Join Date: Sep 1999
Chapter/Region:
NWIC
Location: WA
Vehicle:1970 FF-1 & '70 Van 02 WRX/01 RS |
simple green it... then powerwash it...
dry it off... hit it w/some more simple green in any greasy/rough spots aint gonna get much cleaner than that!' Jamie www.subiegalracing.com |
09-12-2002, 10:07 AM | #5 |
Scooby Specialist
Member#: 17175
Join Date: Apr 2002
Chapter/Region:
Tri-State
Location: ct
Vehicle:2002 Outback Beaner 2 counts, right? |
i found a place in new rochelle,ny that does it (steam cleaning/engine detailing), but that doesn't really help you florida/vermont people. i heard from a number of people that if you cover up the electronics/intercooler you can spray the engine with "Simple Green" then hose it down and start scrubing ("simple Green" eats paint too, so be careful where you spray it). Auto shops sell engine degreaser/cleaner kits in the waxes/polishes section. hope it helps. i know there was a thread about this in the archives too....
|
09-12-2002, 12:58 PM | #6 |
Scooby Newbie
Member#: 20667
Join Date: Jun 2002
Location: Black Hawk, CO
Vehicle:2002 wrx blue pearl |
Just go to your local detail shop. For $100 they will do the engine, buff your car and do the inside. It will make the engine look brand new. Worth every penny.
|
09-12-2002, 08:22 PM | #7 |
Scooby Newbie
Member#: 23786
Join Date: Aug 2002
Location: Vienna, VA
Vehicle:2003 WRX 5-speed Yellow, Sonic Yellow... |
Yeah, similar to Simple Green, you can try Spray9 (available at car parts stores) but it is more potent...
To finish, go mad with Silicone spray. It not puts a great protective coat on hoses, but also lubes the throttle body spring/wire, and puts a nice shine to everything...helps repel water as well. |
09-12-2002, 10:09 PM | #8 |
Gone... But not forgotten
Member#: 16772
Join Date: Mar 2002
Chapter/Region:
AKIC
Location: back in AK
Vehicle:2003 R6 i miss my rex.... |
i use "gunk" engine cleaner it works really good
|
09-13-2002, 12:25 AM | #9 |
Scooby Newbie
Member#: 11034
Join Date: Oct 2001
Location: Jacksonville
Vehicle:2002 WRX Platinum Silver |
I think "gunk" and similiar degreaser are too harsh on the aluminum parts. I'd never thought about using simple green. I always clean the engine after i wash my car with the damp towel i used to dry my car. That way the engine always looks good and its not overwhelming task to detail it, when needed..
|
09-13-2002, 11:50 AM | #10 |
Scooby Newbie
Member#: 16255
Join Date: Mar 2002
Location: CO
Vehicle:2004 Mazda 3 5dr 2013 Mini Cooper S |
I work at a detailing shop.... what we do is wet the whole front of the car down, engine and paint. that's to keep the degreaser from staining the paint. then we spray the whole engine down with degreaser (anykind will work). concentrating on really bad spots, and scrub them if possible. then power wash it clean. there's nothing that can be hurt by this. if your worried next time you go shopping get plastic bags and use them to covor up any worry spots. it'll keep that part dry. then once you use the power waher use a reagular hose and rinse everything off, incling the paint around the engine bay. then use a polish spray.... i can think of any off the top of my head but i'm sure you can find one.
it's that simple and if you do that every couple of months the engine will stay nice and clean. hope that helps. CHAD |
09-13-2002, 01:23 PM | #11 |
Scooby Newbie
Member#: 23622
Join Date: Aug 2002
Location: SoCA
|
what parts would need to be covered before spraying the engine?
|
09-13-2002, 02:22 PM | #12 |
Scooby Newbie
Member#: 15349
Join Date: Feb 2002
Location: Western Michigan
Vehicle:2002 Impreza WRX Black |
The only thing I cover when I do mine is the alternator, and I know some folks who don't even do that. I use a small piece of tin foil, since you can form it really good around it. I also use simple green, and make sure I hose everything down (including the paint around the engine) before and after.
Paul |
09-14-2002, 12:49 AM | #13 |
Scooby Specialist
Member#: 18589
Join Date: May 2002
Chapter/Region:
SCIC
Location: Las Virgenes Cyn, CA
Vehicle:2002 WRX, Formerly it was blue |
Just go easy with the hose, and you should be OK. All engines are made to injest water in the engine comparment, else everything would die when it rains, and you go splashing through puddles.
I would recommend that no one steam clean their engines. I've known quite a few mechanics that spent days, and months trying to figure out all sorts of strange problems with customers cars, only for it to come down to corrided connectors in the engine compartment. Steam cleaning forces moisture into place that splashing water would not get to. Everytime it was in all the wiring connectors, like the fuel injectors, or any mid-wire connectors. |
09-14-2002, 02:02 AM | #14 |
Scooby Specialist
Member#: 17643
Join Date: Apr 2002
Chapter/Region:
SCIC
Location: SoCal 714
Vehicle:2002 WRX Wagon PSM |
Is this okay?
If I goto coin wash
Spray the whole engine with degreaser... Power rinse the whole engine... Spray the whole engine with water without cover anything... Its not gonna hurt anything? Once I start the engine when engine bay is WET, will I be okay? I mean, risk free? |
09-14-2002, 07:41 AM | #15 |
Scooby Specialist
Member#: 453
Join Date: Oct 1999
Location: ***23567;***12373;***12356;***
Vehicle:2020 Kia Telluride 2021 Porsche Taycan |
1. cover up alternator (unless you plan on leaving the engine bay open to air dry for a few hours
2. Simple Green - spray liberally on the engine bay 3. hose down 4. repeat Ed |
09-15-2002, 01:18 AM | #16 |
Scooby Specialist
Member#: 17643
Join Date: Apr 2002
Chapter/Region:
SCIC
Location: SoCal 714
Vehicle:2002 WRX Wagon PSM |
Thanks Ed
|
09-15-2002, 02:10 AM | #17 |
Scooby Newbie
Member#: 15764
Join Date: Feb 2002
Location: Brick NJ
Vehicle:00RS -Dumb all over A little ugly on the side |
One more thing, make sure the engine is cold. You dont want to spray water onto a a hot block. Can potentially crack. I dont have any personal accounts of this but i'ver heard it in a few places. Think of a chilled glass and pur hot water into it. same concept.
|
09-15-2002, 04:23 AM | #18 |
Scooby Specialist
Member#: 19143
Join Date: May 2002
Chapter/Region:
NESIC
Location: West Hartford, CT.
Vehicle:02 WRX |
OK... since you all are talking so highly of simple green I want to get some to try it out. But... where do I get it? Does any random autoparts store carry it? Autozone? Pepboys?
Thank yas |
09-15-2002, 07:33 AM | #19 |
Scooby Newbie
Member#: 15349
Join Date: Feb 2002
Location: Western Michigan
Vehicle:2002 Impreza WRX Black |
You can get simple green at most stores. I got mine at autozone, and I have seen it at Meijer.
|
09-15-2002, 02:29 PM | #20 |
Scooby Specialist
Member#: 19143
Join Date: May 2002
Chapter/Region:
NESIC
Location: West Hartford, CT.
Vehicle:02 WRX |
Cool... thank yas
|
09-15-2002, 03:34 PM | #21 |
Scooby Newbie
Member#: 24213
Join Date: Sep 2002
Location: Orlando, FL
|
After you simple green it, try using CD-2 engine detailer. Spray it on everything, then wipe it off with towels. It cleans, shines and protects. I used this on my '91 Mustang and the original hoses (there was only one actually) looked new. I've gotten many compliments on how clean it is.
Beau |
09-15-2002, 06:34 PM | #22 |
Scooby Newbie
Member#: 16180
Join Date: Mar 2002
Location: Atlanta GA
Vehicle:15 15' DGM STI 02' Bugeye |
wd-40......does the trick
after you clean it and dry it add some wd-40 you shiet will shine like a buh! |
09-15-2002, 07:54 PM | #23 |
Scooby Newbie
Member#: 14561
Join Date: Jan 2002
Location: CT
Vehicle:96 impreza black |
WD-40 works great after you have cleaned it, then all the dirt sticks to the WD40,a nd you can easily powerwash it off, and reapply a fresh coat.
|
09-16-2002, 01:58 PM | #24 |
Scooby Specialist
Member#: 12368
Join Date: Nov 2001
Chapter/Region:
MAIC
Location: Pittsburgh,PA
Vehicle:2008 Infiniti G35X 2011 BMW X5 Diesel |
A while back I posted lots of pics of my engine cleaned and all.
those pics are gone now but it looked great. heres the description: I started by Spraying the engine down with a strong mist type spray on my nozzle. Then I did a more direct hard spray on parts. After that I sprayed some Simple Green all over and let it sit for about 10 mins. After the 10 mins I Hosed that off, then I wiped down some spots with a rag and then I blew all of the water out with a leaf blower. The last thing I did was spray stoners trim shine all over the plastic parts and I took pics right after, thats why it looks SOOO shiny. I already tryed starting it up and it ran fine even though I didnt cover the alternator or the battery at all so no need to worry. Sometime around thanksgiving I will be cleaning the engine once again taking before and after pics to try and help people who are scared of hurting something that it is fine to put some water on it. Bryan |
09-16-2002, 03:04 PM | #25 |
Scooby Specialist
Member#: 17175
Join Date: Apr 2002
Chapter/Region:
Tri-State
Location: ct
Vehicle:2002 Outback Beaner 2 counts, right? |
where to get simple green
you can get simple green at most grocery stores and hardware stores as well as autoparts stores...
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to Clean MAF 02 WRX | RdRx02 | Newbies & FAQs | 10 | 06-02-2010 10:05 PM |
Best way to clean engine bay? | sabubarub | Interior & Exterior Modification | 18 | 11-29-2005 09:12 AM |
Products to clean engine bay? | g0tb00st | Interior & Exterior Modification | 40 | 08-07-2005 12:34 PM |
how to clean engine bay | fosgate769 | Interior & Exterior Modification | 14 | 01-10-2005 10:07 AM |
How to Clean Engine Bay and Underbody? | Josico | Interior & Exterior Modification | 1 | 04-20-2002 07:49 PM |