|
|
|
|
Thread Tools | Display Modes |
08-09-2020, 01:12 PM | #1 |
Scooby Newbie
Member#: 417600
Join Date: Apr 2015
|
JDM 2007 Legacy ECO Mode & Sport Sharp Problems
Good Day All
My name is Christian. I am writing from Trinidad & Tobago. Let me see how best i can break this down. I have a 2007 JDM Legacy Spec B with SI Drive. It came automatic and i did a manual conversion (i left the original ECU and Harness and flashed a manual rom on it) Wired up the reverse lights, Neutral switch, Push button start etc. I did a few changes to the vehicle (Exhaust, Fuel Pump, CAT Delete, water Meth, BOV) Here is the scenario - All 3 Driving Modes (Intelligent, Sport & Sport Sharp) can be engaged. But when i put the car in Sport Sharp and the engine goes under 3500rpm, The ECO light on the gauge cluster comes on and i get an error under my speedometer and the the [s] starts flashing indicating that the car went back into Sport mode. I cannot change the driving mode again unless i switch off the car and start back. I never saw the ECO light come on in Sport Sharp when the car was Automatic. Tried reflashing another ROM and bricked my ECU. I took the ECU to repair and was told that i can look around for an option to get the ECO mode removed or (i dont know if i am saying this correctly) for a tuner to make some changes to the table so the ECO mode WONT come on at 3500rpm. I spoke to a few local tuners who said they will have to look into it because they have never heard about that. I am looking around to see if anyone has/had that issue and what general direction to go to.
* Registered users of the site do not see these ads.
Last edited by bl5_legacy; 08-09-2020 at 10:36 PM. |
08-09-2020, 02:15 PM | #2 |
Scooby Guru
Member#: 90539
Join Date: Jul 2005
Chapter/Region:
South East
Location: SWLA
Vehicle:My BOV goes COVFEFE! |
I'm not familiar with your issue, but you may also want to search this forum since it's for swaps and conversions: https://forums.nasioc.com/forums/forumdisplay.php?f=87
|
08-09-2020, 02:51 PM | #3 |
Scooby Newbie
Member#: 417600
Join Date: Apr 2015
|
I checked around with no luck. It may be something i can do on the ECU thats why i posted it here
|
Thread Tools | |
Display Modes | |
|
|