|
|
|
|
Thread Tools | Display Modes |
04-05-2023, 08:16 PM | #1 |
Scooby Newbie
Member#: 431091
Join Date: Sep 2015
|
Replaced transmission casting now no reverse
I recently had the clutch fork shaft come loose and cracked the bell housing for transmission. I replace the casing transferred gears from old on put together and now I’m having an issue i have gears 1-5 but cannot shift into reverse position just trying to figure out what to look for. This is a 5speed gear box for my 05 WRX.
Any information would help. Please and thank you ahead of time.
* Registered users of the site do not see these ads.
|
04-09-2023, 08:50 PM | #2 |
Scooby Specialist
Member#: 283429
Join Date: May 2011
Chapter/Region:
South East
Location: Down yonder.
Vehicle:2016 Fuji Sunfire 03 Silver |
Did you loosen the reverse check sleeve on the side of the extension housing? You have to loosen those two 10mm head bolts so that you can rotate reverse fork to get the shifter engaged with all the gates on the rails. You can get reverse rail gate out of location because it is not interlocked with the other 3 rails.
|
04-10-2023, 08:16 PM | #3 | |
Scooby Newbie
Member#: 431091
Join Date: Sep 2015
|
Quote:
I did not do this i will attempt tomorrow it was my first time ever doing anything with the transmission so all new to me i was trying to learn. |
|
Thread Tools | |
Display Modes | |
|
|