|
|
|
|
Thread Tools | Display Modes |
|
10-06-2009, 03:34 AM | #1 |
Scooby Newbie
Member#: 210762
Join Date: May 2009
Location: Greensboro, NC
Vehicle:2005 Legacy GT GRP |
Tune from Motion Lab Tuning in Charlotte, NC
Got the Legacy tuned by Todd (tmarcel) at Motion Lab Tuning via a remote tune and it felt it was making some great power so we brought the car down to him and he fine tuned it on the dyno. Here are the specs:
Stock EJ255 Block Stock VF40 Turbo Stock TMIC with JB Weld on edges GTSpec Exhaust Manifold and Uppipe - DEI Wrapped RPA Divorced Wastegate Downpipe - DEI Wrapped RPA EBCS RPA Short Ram Intake RPA Catback Exhaust The graph below shows the two best runs on the Dyno Dynamics dyno with no additional corrections. The car is currently getting an FMIC Installed as the TMIC can not keep up and will be back on the dyno next week to see how it changes the numbers. |
10-06-2009, 03:34 AM | #2 |
Scooby Newbie
Member#: 210762
Join Date: May 2009
Location: Greensboro, NC
Vehicle:2005 Legacy GT GRP |
Here is an STI (stock turbo) that was tuned on the same dyno for comparison
|
10-26-2009, 11:27 AM | #3 |
Scooby Newbie
Member#: 210762
Join Date: May 2009
Location: Greensboro, NC
Vehicle:2005 Legacy GT GRP |
UPDATE: Took it to the drag strip
I have always been intrigued by the drag strip and finally decided to get up and go today. I made some runs by myself as well as running against a turbocharged Mazda MX6. I was the only import there until the Mazda showed up. The runs were made the 1/8th mile Piedmont Dragway which is at around 880 ft elevation. I have done some autocross and other similiar events but this was my first time at the drag strip and I felt pretty good as I got more runs in and believe once I improve my launching and driving I can shave off a bit more of my time. Here are the runs R/T .772 60' 1.939 330 5.609 1/8 8.693 MPH 81.79 ------- Legacy ---- ---- MX-6 R/T ---- .785 ---- ----- .646 60' ---- 1.882 ---- ----- 2.106 330 --- 5.632 ---- ----- 5.838 1/8 --- 8.705 ---- ----- 8.794 MPH -- 82.13 ---- ----- 84.31 ------- Legacy ---- ---- MX-6 R/T ---- .846 ---- ----- .644 60' ---- 2.084 ---- ----- 2.202 330 --- 5.874 ---- ----- 6.084 1/8 --- 8.953 ---- ----- 8.980 MPH -- 82.46 ---- ----- 87.91 Once I improve my launching and driving I believe I should be able to get to low 8s Here is a video of the first run where you can hear some of the comments |
11-04-2009, 04:05 PM | #4 |
Scooby Newbie
Member#: 210762
Join Date: May 2009
Location: Greensboro, NC
Vehicle:2005 Legacy GT GRP |
Went to the quarter mile at Zmax Dragway last night. We did a little retuning before the runs but the car was a bit rich seeing 10.5 AFR's and the laptop battery was done by the second run so we didn't get a chance to retune for the last few runs. The best slip of the day is below:
R/T --- 0.066 60' ---- 1.861 330 --- 5.556 1/8 ---- 8.613 MPH --- 80.56 1000 -- 11.213 ET -----13.385 MPH ---104.07 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Motion Lab Tuning | Stock wagon | Newbies & FAQs | 5 | 01-10-2010 08:04 AM |
Motion Lab Tuning in Charlotte, NC | Motion Lab Tuning | South East Region Forum | 30 | 11-19-2009 10:13 PM |