|
|
|
|
Thread Tools | Display Modes |
10-18-2013, 08:53 PM | #12376 |
Scooby Specialist
Member#: 342985
Join Date: Jan 2013
Chapter/Region:
Tri-State
|
SlowScoobie, love it.
Attempted my coil-over install today. Could only get the front 19mm camber bolt to move 1/4 turn, even with a breaker-bar/3ft. pipe extension. PB blasted it as well. Will try again with an electric impact. Also, does anyone know a company that makes the exact front lower control REAR bushing? Noticed today both of them on my car are shot. Cracking pretty bad. I know Whiteline is a company but not sure which bushing it is in the pictures. It is definately a vertical bushing when looking at the lower control arm. Thanks!
* Registered users of the site do not see these ads.
|
10-18-2013, 08:54 PM | #12377 | |
Scooby Specialist
Member#: 262503
Join Date: Oct 2010
Chapter/Region:
MWSOC
Location: Minneapolis
Vehicle:2008 Impreza 2.5i |
Quote:
|
|
10-18-2013, 08:58 PM | #12378 |
Scooby Newbie
Member#: 312011
Join Date: Feb 2012
Location: Ontario Canada
Vehicle:2009 impreza 2.5i white |
|
10-18-2013, 09:00 PM | #12379 | |
Scooby Specialist
Member#: 301179
Join Date: Nov 2011
Chapter/Region:
BAIC
Location: California
Vehicle:2013 WRX Limited SWP |
Quote:
I believe its W0507 from whiteline. Good luck. |
|
10-18-2013, 09:21 PM | #12380 | |
Scooby Specialist
Member#: 320464
Join Date: May 2012
Chapter/Region:
Tri-State
Location: Monmouth, NJ
Vehicle:2005 Legacy GT ABP |
Quote:
|
|
10-18-2013, 09:38 PM | #12381 | ||
Scooby Specialist
Member#: 342985
Join Date: Jan 2013
Chapter/Region:
Tri-State
|
Quote:
Quote:
http://www.whiteline.com.au/product_..._number=W53353 Pretty sure that is it judging by the picture of the bushing and the description. Now off to find a DIY on replacing these suckers because nothing goes easy! |
||
10-18-2013, 09:45 PM | #12382 |
Scooby Specialist
Member#: 262503
Join Date: Oct 2010
Chapter/Region:
MWSOC
Location: Minneapolis
Vehicle:2008 Impreza 2.5i |
|
10-19-2013, 12:09 PM | #12383 |
Scooby Newbie
Member#: 312011
Join Date: Feb 2012
Location: Ontario Canada
Vehicle:2009 impreza 2.5i white |
So far so good!! I put the new donut gasket on and there seems to be no leaks so far, the gasket didn't go in the greatest it was a tight fit on the existing pipe I cleaned it the best I could but there was still a little rust
|
10-19-2013, 02:32 PM | #12384 |
Scooby Newbie
Member#: 362680
Join Date: Jul 2013
Location: Salt Lake City, Utah
Vehicle:2009 Impreza 2.5i |
So I've been doing a little scratch removal today... It's not fun!.
|
10-19-2013, 04:05 PM | #12385 |
Scooby Specialist
Member#: 301179
Join Date: Nov 2011
Chapter/Region:
BAIC
Location: California
Vehicle:2013 WRX Limited SWP |
Thats good. Sounds like your old gasket had been worn down.
|
10-19-2013, 09:35 PM | #12386 |
Scooby Specialist
Member#: 342985
Join Date: Jan 2013
Chapter/Region:
Tri-State
|
Installed Rallitek skidplate. Definately a nice product, really nice skidplate. Except, they sent my 4 wrong washers (Rallitek---you only needed to supply 6 washers an 6 bolts... c'mon!) and the rear tabs were a PITA to line up. That skidplate is on for good!
Now, please someone buy my brand new coil-overs so I don't have to try installing them again and make my winter/daily not practical! Last edited by DownhillSubie; 10-19-2013 at 09:44 PM. |
10-19-2013, 10:44 PM | #12387 | |
Scooby Specialist
Member#: 262503
Join Date: Oct 2010
Chapter/Region:
MWSOC
Location: Minneapolis
Vehicle:2008 Impreza 2.5i |
Quote:
Why Racelands coilovers? Tsk tsk. |
|
10-20-2013, 10:34 AM | #12388 |
Scooby Newbie
Member#: 312011
Join Date: Feb 2012
Location: Ontario Canada
Vehicle:2009 impreza 2.5i white |
Fancyfootwork, did the oem spring bolts fit your exhaust?
Last edited by Cmac13; 10-20-2013 at 10:40 AM. |
10-20-2013, 11:22 AM | #12389 |
Scooby Specialist
Member#: 262503
Join Date: Oct 2010
Chapter/Region:
MWSOC
Location: Minneapolis
Vehicle:2008 Impreza 2.5i |
|
10-20-2013, 12:38 PM | #12390 |
Scooby Newbie
Member#: 312011
Join Date: Feb 2012
Location: Ontario Canada
Vehicle:2009 impreza 2.5i white |
|
10-20-2013, 12:52 PM | #12391 | |
Scooby Specialist
Member#: 342985
Join Date: Jan 2013
Chapter/Region:
Tri-State
|
Quote:
Because its just a daily. Not dumping alot of money into it. Already have my Audi as a show car/project and a 1991 black/black Mercedes 420SEL with 26k miles on it--- aka garage queen. So yes, Subaru budget was race lands and must say, they look way nicer than I was expecting. 2 year warranty is sweet too. |
|
10-20-2013, 01:16 PM | #12392 | |
Scooby Specialist
Member#: 262503
Join Date: Oct 2010
Chapter/Region:
MWSOC
Location: Minneapolis
Vehicle:2008 Impreza 2.5i |
Quote:
|
|
10-20-2013, 01:59 PM | #12393 |
Scooby Specialist
Member#: 283606
Join Date: May 2011
Chapter/Region:
Tri-State
Location: Red Bank,NJ
Vehicle:2008 Impreza 2.5i Silver |
|
10-20-2013, 02:35 PM | #12394 |
Scooby Specialist
Member#: 262503
Join Date: Oct 2010
Chapter/Region:
MWSOC
Location: Minneapolis
Vehicle:2008 Impreza 2.5i |
^ if I didn't just drop over 2k I probably would've considered those gram lights
|
10-20-2013, 02:43 PM | #12395 |
Scooby Specialist
Member#: 146287
Join Date: Apr 2007
Chapter/Region:
BAIC
Location: NOR-CAL (South Bay Area)
Vehicle:2011 Impreza WRX 5D Satin White Pearl |
Severe lack of photos lately...
|
10-20-2013, 02:47 PM | #12396 |
Scooby Specialist
Member#: 283606
Join Date: May 2011
Chapter/Region:
Tri-State
Location: Red Bank,NJ
Vehicle:2008 Impreza 2.5i Silver |
|
10-20-2013, 10:37 PM | #12397 |
Scooby Newbie
Member#: 321595
Join Date: May 2012
Chapter/Region:
NWIC
Location: Portlant Oregon
Vehicle:2005 Legacy GT Silver |
Hey if anyone is looking for a nice exhaust I have a Borla Catback that had been sitting in my garage for months now! http://forums.nasioc.com/forums/show....php?t=2544652
Last edited by Devon; 10-21-2013 at 12:27 PM. |
10-21-2013, 07:40 PM | #12398 |
Scooby Specialist
Member#: 262503
Join Date: Oct 2010
Chapter/Region:
MWSOC
Location: Minneapolis
Vehicle:2008 Impreza 2.5i |
|
10-21-2013, 08:19 PM | #12399 | |
Scooby Specialist
Member#: 251060
Join Date: Jul 2010
Location: Schenectady, NY
Vehicle:2008 Impreza Outback Black |
Quote:
|
|
10-21-2013, 08:35 PM | #12400 |
Scooby Specialist
Member#: 276915
Join Date: Mar 2011
Chapter/Region:
MAIC
Location: Pittsburgh (South Hills)
Vehicle:2011 WRX Limited Satin White Pearl |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
08 2.5i and 08 Sti Suspension | WRXbrother | Brakes, Steering & Suspension | 10 | 08-22-2017 12:30 AM |
Will an 08 WRX intake fit an 08 2.5i? | Racing101 | Normally Aspirated Powertrain | 26 | 01-19-2012 11:57 AM |
08 STI Wing on 08 2.5i impreza | juny102004 | Interior & Exterior Modification | 13 | 01-18-2012 09:46 AM |
Will 08+ WRX gauges swap into 08+ 2.5i? | Simeon Priest | Interior & Exterior Modification | 10 | 03-26-2010 02:17 PM |
08 2.5i mod question | deunique1 | Impreza Forum | 1 | 10-03-2007 02:35 PM |