|
|
|
|
Thread Tools | Display Modes |
04-01-2011, 06:59 PM | #1 |
Scooby Specialist
Member#: 257866
Join Date: Sep 2010
Chapter/Region:
Tri-State
Location: Southwestern Ct
|
Couldnt find a BPV Elbow, fed up, making my own, ID, OD, Wall thickness?
Was wondering if any of you guys knew or knew where to find or could possibley measure the Outer diameter, Inner Diameter, and wall thickness of the STi bypass valve elbow. Really need one, cant find one, making my own out of 6061 T651 aluminum.
I know its an odd request, but if any of you knew or could measure for me I would really appreciate it! Thanks! Andy
* Registered users of the site do not see these ads.
|
04-01-2011, 08:24 PM | #2 |
Scooby Specialist
Member#: 5810
Join Date: Apr 2001
Chapter/Region:
Tri-State
Location: Easton PA
Vehicle:2001 S366 2.5RS |
The recirq elbow? If so and you can wait till sunday ill get the measurements for ya
|
04-01-2011, 09:53 PM | #3 |
Scooby Specialist
Member#: 257866
Join Date: Sep 2010
Chapter/Region:
Tri-State
Location: Southwestern Ct
|
Yessir, its fine though, kinda figured it out, its just about done. Just need to square off the flange and drill the wholes. Will post pics when done! Haha
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Burn-up side skirts were too expensive so I'm making my own!!!! | Patu | Member's Car Gallery | 108 | 05-20-2007 08:49 PM |
I want to make my own grouding kit for my engine what do i need | bottlediger | Car Audio, Video & Security | 8 | 12-26-2005 05:21 PM |
Fed up with my Sti | Mikemar | Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo) | 30 | 01-07-2005 11:49 PM |
Columbus : fed up with my clutch | iceweazel | Mid West Subaru Owners Club Forum -- MWSOC | 11 | 04-23-2002 05:37 PM |
How do I make my own decals on my printer? | Andrew | General Forum Archive | 2 | 12-14-2000 04:44 AM |