|
|
|
|
Thread Tools | Display Modes |
05-28-2009, 02:17 PM | #1 |
Scooby Newbie
Member#: 212398
Join Date: May 2009
|
A question about 2009 Impreza 2.5i shifter bushings...
So I went to install my aftermarket shifter bushings.
I read up on this install before I attempted it and noticed that most installs make comment of a "hook washer" holding the shifter bushing/rod on, then the bolt. My car did not have this washer. The bolt was held right against the bushing. Is this correct? My car is missing the below "hook washer":
* Registered users of the site do not see these ads.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2009 Impreza 2.5i Conversion wrx engine swap? | bushwahkhan | Subaru Conversions | 45 | 12-12-2020 08:29 PM |
Help with 2009 Impreza 2.5i Wagon NON TURBO | subie_girl | Newbies & FAQs | 21 | 12-03-2009 02:47 PM |
FRESH 2009 Impreza 2.5i (watchout) | CrotchMonster | Member's Car Gallery | 27 | 03-30-2009 01:56 PM |
2009 Impreza 2.5i radio install and bezel same as 2008? | Fustern | Car Audio, Video & Security | 3 | 02-23-2009 08:03 PM |
Questions about 08 impreza 2.5i performance modifications | shjake24 | Newbies & FAQs | 5 | 08-11-2008 07:18 PM |