Quote:
Bought the full light kit from rallysportdirect. Shipped quick.
FYI guys, you can install without removing bumper. Was simple.
1. Backed car into garage to work in warmth.
2. Underneath rear bumper you will see two push tabs holding bumper cover on, popped them off.
3. Was able to slide hands in between bumper cover and body (pulling cover with other hand away from car a little)....was able to pop out the black mesh filler piece by pushing the tabs out left to right on the bottom of piece through back of bumper cover.
4. Took apart trunk to locate plugged hole near bottom of drivers tail lamp area.
5. Cut mesh filler piece according to marks I made from mocking light up to the center piece.
6. Installed light and mesh filler pieces according to OP's tips on page 3.
7. For wiring, now back to trunk, I took the plug out(push out from interior and it will drop to ground by exhaust) I fished a thin 2' length of string through hole down to ground. Tied string around plug on supplied wire harness and pulled it up through the hole until supplied hole plug came into place.
8. Back underneath car, clipped wire harness (using clips already attached to harness) to bottom of bumper beam, you will see where to clip to once underneath car.
9. I tapped my wire harness into my rear parking lights so when ever lights are on, rear fog is on. Cut plug off harness and spliced,soldered into factory wires.
10. Had girlfriend turn on lights to test, all works great. Put everything in trunk back together, put push tabs back on bottom of bumper cover. All set to go and looks great.
Hope this may help any of you. Saves some time from removing full bumper cover.
Any Pictures? I am from NY too.