|
||||||||||||||||
![]() |
|
|
|||||||




![]() |
|
|
Thread Tools | Display Modes |
|
|
#1 |
|
Scooby Specialist
Member#: 62629
Join Date: May 2004
Chapter/Region:
MAIC
Location: Richmond,VA
Vehicle:1996 OBS in Green 2.5 N/A w/ full exhaust |
Hi folks, I need a little help. I just finished helping a friend put a '98 DOHC EJ25 into his L. We kept the 2.2L ECU for the moment. I had to rewire the injector part of the harness because it had been altered by the previous owner to use Silvia injectors.
The engine soon threw a P0262 code, Cyl #1 Fuel Injector Circuit High Input. The motor runs like its on three cylinders so I suspect the ECU is shutting Cylinder #1 down and something. I replaced the injector with another but got the code again after clearing it the first time. I suspect the wiring which I soldered but I could use any additional advice on tracking this down fast as we are supposed to drive this car to Birmingham AL for the Grand Am cup race. Thanks Greg
* Registered users of the site do not see these ads.
|
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 93 Impreza trouble codes | Marinator | Normally Aspirated Powertrain | 2 | 04-15-2006 11:02 PM |
| Trouble codes? | amelnikov | Factory 2.0L Turbo Powertrain | 2 | 09-14-2001 03:01 PM |
| How to pull a trouble code? Help plz | AcIdRoX | Normally Aspirated Powertrain | 1 | 08-07-2001 08:55 AM |
| Trouble code description? | Greg555 | General Forum Archive | 3 | 02-21-2001 12:03 AM |
| Trouble codes wanted | AndyHidley | Technical Forum Archive | 1 | 06-01-2000 08:56 AM |