|07-30-2006, 06:20 PM||#1|
Join Date: Oct 2003
Location: San Francisco, CAVehicle:
2002 WRX Wagon
1st Guru Point EvAr!
My rear 02 Sensor got wet and my car never ran better!
I recently replaced my front 02 sensor finally only giving me a P0136 code of an 02 circuit malfunction on my rear sensor.
Custom Track Pipe(No cats)
Apexi N1 cat-back
I drove in some rain and went through a HUGE puddle. Immediately, my car bogged and it did for another minute till it dried out underneath. Later that day, I cranked up my car and NO CEL! It was a miracle and my car was running great! Unfortunately, it came back and it's the same code.
I assume water temporarily killed my rear 02 and somehow erased the code.
Is there a way I can keep it that way? Do I need to replace the sensor? (it is currently unplugged and runs OK, but CEL remains)
Awhile back I installed an MIL Eliminator, but it never worked very long.
I just want SOMETHING(ANYTHING) to fix or get rid of my CEL. Any help or advice is appreciated.
Thanks in advance!
CN-Water bogged rear 02 sensor(I think) making my car run great temporarily. How can I get rid of P0136 CEL code?
* Registered users of the site do not see these ads.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Front 02 Sensor,Rear 02 Sensor,MAF Sensor,Blox Shift Knob,SPT Oil Cap, bunch of stuff||TopEndPull||Engine/Power/Exhaust||11||08-14-2009 06:48 PM|
|Needed: 02 WRX full STOCK exhaust. Headers upipe and turbo back, rear 02 sensor.||munkis||Tri-State Area Private Classifieds||5||01-03-2007 04:16 AM|
|WTB/ rear 02 sensor and harness||qwkwrx||Private 'Wanted' Classifieds||2||09-19-2005 03:48 AM|
|My rear axle boot got hit by my exhaust?||waitandbleed92||Transmission (AT/MT) & Driveline||4||02-21-2004 12:11 AM|
|Rear 02 sensor and pop in insert piece||joemoidel||Private 'Wanted' Classifieds||2||08-10-2003 11:33 PM|