|10-12-2006, 02:54 PM||#1|
Join Date: Oct 2005
Location: Phoenix, AZVehicle:
2002 Wrx Sedan
AZ:5speed trans/kartboyss/3.90 r&p
04 5speed tranny. It shifts and drives fine, it is making a noise which sounds like the input shaft bearing. - offer
A broken R160 - offer
5speed driveshaft - offer
6speed shift linkage. The bottom linkage bar is bent a little and the rubber boot is torn. I used it for a little while and it worked fine, the shifter just rest more to the right. - $20 shipped
5speed linkage with Kartboy short shifter.- $75 shipped SOLD
5speed knob - offer
Front and Rear cv axles -offer
3.90 ring & pinion- $110 shippedSOLD
Starter from an STi - offer
I am trying to get my friends camera so I can take some pictures. If you have a certain request let me know. I am not expecting much for anything so give me an offer even if you think it might be lowballing.
* Registered users of the site do not see these ads.
Last edited by Smoby; 10-15-2006 at 01:02 PM.
|Thread||Thread Starter||Forum||Replies||Last Post|
|DIY: 3.90 R&P Install???||scooby2.0t||Transmission (AT/MT) & Driveline||5||08-08-2008 09:03 PM|
|3.90 R&P gears! Perfect for 6 speed swap!||scooby2.0t||Drivetrain||4||02-19-2008 10:17 PM|
|R160 diff 3.90 R&P||kayen||Drivetrain||2||04-20-2007 08:25 PM|
|Socal/SD:R160, 3.90 R&P, Axles, Hubs, Driveshaft, TMIC, Td04, STI 6mt Clutch/Flywheel||gimmewar||Private 'For Sale' Classifieds||3||05-13-2006 04:14 AM|
|Socal/SD:R160, 3.90 R&P, Axles, Hubs, Driveshaft, TMIC, Td04, STI 6mt Clutch/Flywheel||gimmewar||SCIC Private Classifieds||0||05-13-2006 03:43 AM|