|12-06-2006, 11:25 AM||#1|
Join Date: Feb 2006
Location: Salt Lake cityVehicle:
PID + GMBCS quick thought
I have been running PID/GMBCS for a while now and I have been getting lots of differnt results as Im tuning.
I just thought of something that I am going to play around with tonight. after work.
The 0% colm for pid is used for target boost in PSI (duh), and the rest of the map is BCS DC targets.
Im going to try this part - if I set my boost target 3 PSI lower than my target and bump the BCS DC #s up, does it sound possible that I will be hitting target boost at 3 PSI higher than that of the PID map?
my target boost right now is 17.5
so the 0% will be 14.5 and raise the numbers from say 55 to 85 or from 60 to 90.
either way I will post up some results
* Registered users of the site do not see these ads.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Need help quick on springs||g7run||Brakes, Steering & Suspension||0||06-03-2010 02:57 PM|
|XPT stage 2 w/o GMBCS to w/ GMBCS||BradsWRX||Open Source Reflashes||6||04-03-2010 05:43 PM|
|Quick thought about uppipe leaks and installs...||DTECH-WRX||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||4||01-07-2004 09:00 AM|
|quick thought on cheap turbo kit attn: experts||rupteur7000||Normally Aspirated with bolt-on Forced Induction Powertrain||6||04-12-2002 09:54 PM|
|just had a quick thought about cat efficiency||ellisnc||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||2||03-24-2002 10:19 AM|