Via radio, the system transmits the air pressure and
temperature measured in the tyres to a control unit which
is connected to a display mounted in the vehicle interior.
display unit, the user has the facility to
configure the system and to call up and acknowledge
The system can monitor seven tyres (2 x front, 4 x rear,
spare tyre) and clearly displays the status of the tyres on a
multi-colour display with seven different background
colours. The symbols of the display have been designed
especially for rapid recognition of the tyre state.
The system is simply connected to the vehicle electric
system and is immediately ready for use after
installation of the tyre sensors. As the system is
supplied with factory preset tyre positions, no
programming is necessary here. The sensors are
marked according to the programmed position, so that
display of the individual tyre states is possible even
without programming. If a fault is present, it is therefore
possible for the driver to receive a specific statement
in relation to the tyre concerned.
A specialist garage must be consulted for fitting the
sensors, as the sensor is fitted instead of the normal valve
in the rim. After balancing and inflation of the tyres, the
wheels can be fitted again, and, via the control fields of the display, the system is programmed with
the current pressure as a reference value (nominal pressure). After these steps, the system is ready
A complete system is shown here.
Unique to the TC-400
is the adjustable background colour of the display. The look of the display can thus be matched to the vehicle-specific instrument lighting.
For installation of the control system, the sensor valves must be fitted to all four wheels.
Further information for downloading:
***********TC-400 Step by Step: 0,6 MB