|02-05-2008, 05:53 PM||#1|
Join Date: Aug 2003
04 GT3076 2.1
Stroker = Broken 3rd
Anyone have the maf scaling values for an Perrin Big MAF. Stock WRX injectors
Does anyone have the MAF scaling values using stock wrx injectors.
This means if you have an 02-05 wrx with a big maf using stock injectors what are your maf scaling used. (This one is probably unlikely)
06-07 wrx using perrin big maf using stock injectors.
* Registered users of the site do not see these ads.
|02-05-2008, 06:57 PM||#2|
*** Banned ***
Join Date: May 2006
Location: UDel, illidelphiaVehicle:
2006 vf39 R0mRa1DeR
First, calculate the cross sectional area of each intake at the maf.
Stock is Pi*(65/2)^2 (65mm diameter)
The multiplier is: Perrin area / Stock area , and should be greater than 1 in this case.
Multiply the entire maf table (stock) by the multiplier and that's your new table.
This will get you pretty close, depending on how well the perrin is designed.
I would increase the multiplier by a few percent, just to make sure you'll be running rich when you actually start tuning the table.
|Thread||Thread Starter||Forum||Replies||Last Post|
|lots of stuff for sale: perrin big maf intake, wideband kit etc..||D&D Tuning||Engine/Power/Exhaust||4||03-20-2009 02:09 PM|
|Anyone have an opinion on modifying stock wrx injectors?||chosen_cartel||South West Impreza Club Forum -- SWIC||25||10-08-2007 10:55 AM|
|Few New in the Box Parts Turbo XS Intercooler, Perrin Big Maf, Perrin 3 inch Inlet||mrtrex||Engine/Power/Exhaust||6||07-23-2007 09:40 AM|
|Ma; For Sale Perrin Big Maf,||xfactor23||Engine/Power/Exhaust||2||12-03-2006 11:55 PM|
|Does anyone have the Greddy Front Lip for the WRX in Stock???||dman918||Interior & Exterior Modification||1||01-08-2003 11:02 AM|