FS: Rear Sway, rear diff bushings, cobb NA intake

nySulli · 12-31-2008, 10:13 AM

looking to finally sell a few pieces off my old 04 RS now that its been gone over a month

all parts pulled off an 04 Impreza RS sedan

Cobb NA Cold Air Intake

seen a few years of use, between me and the original owner its probably seen less then 40k miles, no cracks on the filter housing, but it is missing the silicon piece that goes on the end into the fender. It will comes with a piece of braided fuel line thats been cut open to line the hole into the fender which serves the same purpose as the missing piece. It has the IAT hole in it, but it can be sealed, I'll leave that up to the buyer though

SOLD

Perrin Rear Sway bar + mounts

This is the older style bar with the beefy drop down mounts. It saw 4 years of use while I owned it year round, and at least 1 year before I bought it used so its missing some paint, has some rust, and 1 of the mounting holes on either side has been hit with a drill which enlarged the hole, which could effect using that hole. Also comes with hardly used energy bushings which allow for regreasing without removal of the bushing (just has a grease port)

$75 + shipping

Kartboy Rear diff inserts

I bought these new, only put a few thousand miles on the car before it was sold, 6 months of use only

$20 shipped

I'll give it a few days, but after that I'm open to any reasonable offers

* Registered users of the site do not see these ads.

Quadsbc · 01-01-2009, 12:45 PM

pmed ya! cobb intake...

nySulli · 01-05-2009, 03:20 PM

PM's responded to

Quad, didn't mention it in my PM, but just to point out, the intake is for Naturally Aspirated engines, not turbo, just want to make sure since you have a wrx listed as your ride.

Quadsbc · 01-05-2009, 04:45 PM

Yeah, I know, I have an aps intake already Its for my buddys saabaru

Vtwrx04 · 01-06-2009, 06:26 AM

pm sent

nySulli · 01-06-2009, 07:20 AM

Just making sure

and I'll have pictures out to those who asked tonight

Quadsbc · 01-10-2009, 01:38 PM

thanks for the intake! great seller!

12-31-2008, 10:13 AM	#1
nySulli Scooby Specialist Member Sales Rating: (1) Member#: 32617 Join Date: Feb 2003 Chapter/Region: Tri-State Location: NY Vehicle: 2008 STi DGM	FS: Rear Sway, rear diff bushings, cobb NA intake looking to finally sell a few pieces off my old 04 RS now that its been gone over a month all parts pulled off an 04 Impreza RS sedan Cobb NA Cold Air Intake seen a few years of use, between me and the original owner its probably seen less then 40k miles, no cracks on the filter housing, but it is missing the silicon piece that goes on the end into the fender. It will comes with a piece of braided fuel line thats been cut open to line the hole into the fender which serves the same purpose as the missing piece. It has the IAT hole in it, but it can be sealed, I'll leave that up to the buyer though SOLD Perrin Rear Sway bar + mounts This is the older style bar with the beefy drop down mounts. It saw 4 years of use while I owned it year round, and at least 1 year before I bought it used so its missing some paint, has some rust, and 1 of the mounting holes on either side has been hit with a drill which enlarged the hole, which could effect using that hole. Also comes with hardly used energy bushings which allow for regreasing without removal of the bushing (just has a grease port) $75 + shipping Kartboy Rear diff inserts I bought these new, only put a few thousand miles on the car before it was sold, 6 months of use only $20 shipped I'll give it a few days, but after that I'm open to any reasonable offers * Registered users of the site do not see these ads. Last edited by nySulli; 01-07-2009 at 08:24 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FS: 17mm WRX Rear Sway Bar w/ Bushings	sanremo_russ	North West Impreza Club Forum -- NWIC	2	11-07-2005 12:21 PM
FS: OEM '04 WRX Wagon Rear Sway bar and bushings	skivvie	Bay Area Impreza Club Forum -- BAIC	0	11-05-2004 02:06 PM
FS: FHI 18mm Rear Sway bar w/bushings	Subie Gal	North West Impreza Club Forum -- NWIC	0	10-04-2004 01:20 PM
FS: 03 WRX front and rear sway bars w/ Bushings and MBP Hood Scoop	Silky	Bay Area Impreza Club Forum -- BAIC	2	08-09-2004 09:49 PM
FS: 17mm rear sway bar w/bushings...	Prairie Dawg	Texas Impreza Club Forum -- TXIC	0	01-16-2003 12:56 PM

01-01-2009, 12:45 PM	#2
Quadsbc Scooby Specialist Member Sales Rating: (33) Member#: 170415 Join Date: Jan 2008 Chapter/Region: NESIC Location: Not in Japan but rhd? Vehicle: 2002 Hardware store bumper clips, that is all	pmed ya! cobb intake...

01-05-2009, 03:20 PM	#3
nySulli Scooby Specialist Member Sales Rating: (1) Member#: 32617 Join Date: Feb 2003 Chapter/Region: Tri-State Location: NY Vehicle: 2008 STi DGM	PM's responded to Quad, didn't mention it in my PM, but just to point out, the intake is for Naturally Aspirated engines, not turbo, just want to make sure since you have a wrx listed as your ride.

01-05-2009, 04:45 PM	#4
Quadsbc Scooby Specialist Member Sales Rating: (33) Member#: 170415 Join Date: Jan 2008 Chapter/Region: NESIC Location: Not in Japan but rhd? Vehicle: 2002 Hardware store bumper clips, that is all	Yeah, I know, I have an aps intake already Its for my buddys saabaru

01-06-2009, 06:26 AM	#5
Vtwrx04 Scooby Newbie Member Sales Rating: (6) Member#: 97147 Join Date: Sep 2005 Chapter/Region: NESIC Location: Vermont Vehicle: 2012 wrx gray	pm sent

01-06-2009, 07:20 AM	#6
nySulli Scooby Specialist Member Sales Rating: (1) Member#: 32617 Join Date: Feb 2003 Chapter/Region: Tri-State Location: NY Vehicle: 2008 STi DGM	Just making sure and I'll have pictures out to those who asked tonight

01-10-2009, 01:38 PM	#7
Quadsbc Scooby Specialist Member Sales Rating: (33) Member#: 170415 Join Date: Jan 2008 Chapter/Region: NESIC Location: Not in Japan but rhd? Vehicle: 2002 Hardware store bumper clips, that is all	thanks for the intake! great seller!