WTB: Transmission to use in my EJ205 swapped GC8

former3g · 04-18-2009, 12:47 PM

I need a trans for my swapped '01 RS.. Right now it has a stock trans that has some issues. I'm looking for either a built RS trans or a strong 02 - 07 WRX trans or possibly a JDM trans. I need a trans that will be reliable with the following setup. I may try to pull a bit more power. I would prefer aftermarket gears (i.e. RA or MFactory). I will prefer low mileage, no grinds, no reverse issues, etc...

Power wise, the car has the following mods once it will be running again:
USDM EJ205 from '02 WRX
Cobb Stage 2
Go Fast Bits pulleys
1 step colder ngk plugs denso ik22
tre performance 255 fuel pump
Catless uppipe
I was told it may have cobb camshafts...

I'm willing to send back stock tranny (pretty sure its only the center diff or bearings since it shifts smoothly and still drives) and / or another spare trans that has potentialy bad chelak aftermarket gears in a stock RS box if it can save me any cash.

Vendors or private please apply... If you're a local shop in the New Jersey area, I would like installed prices please. Heck if someone is willing to rebuild the spare trans, please apply too. I have money on hand and ready to go. I want this car running!

My location is North New Jersey (zip 07843). Feel free to PM, call 201-317-4691 or email scoobaru1278@yahoo.com

Thanks!

- Phil

* Registered users of the site do not see these ads.

04-18-2009, 12:47 PM	#1
former3g Scooby Specialist Member Sales Rating: (8) Member#: 58858 Join Date: Apr 2004 Chapter/Region: Tri-State Location: Morristown, NJ Vehicle: '01 RS EJ205 (sold) '10 VW GTI,'10 EVO X GSR	WTB: Transmission to use in my EJ205 swapped GC8 I need a trans for my swapped '01 RS.. Right now it has a stock trans that has some issues. I'm looking for either a built RS trans or a strong 02 - 07 WRX trans or possibly a JDM trans. I need a trans that will be reliable with the following setup. I may try to pull a bit more power. I would prefer aftermarket gears (i.e. RA or MFactory). I will prefer low mileage, no grinds, no reverse issues, etc... Power wise, the car has the following mods once it will be running again: USDM EJ205 from '02 WRX Cobb Stage 2 Go Fast Bits pulleys 1 step colder ngk plugs denso ik22 tre performance 255 fuel pump Catless uppipe I was told it may have cobb camshafts... I'm willing to send back stock tranny (pretty sure its only the center diff or bearings since it shifts smoothly and still drives) and / or another spare trans that has potentialy bad chelak aftermarket gears in a stock RS box if it can save me any cash. Vendors or private please apply... If you're a local shop in the New Jersey area, I would like installed prices please. Heck if someone is willing to rebuild the spare trans, please apply too. I have money on hand and ready to go. I want this car running! My location is North New Jersey (zip 07843). Feel free to PM, call 201-317-4691 or email scoobaru1278@yahoo.com Thanks! - Phil * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What clutch to use in my swap?	DegNY	Transmission (AT/MT) & Driveline	4	11-20-2009 06:25 PM
What Fluids would you recoment to use in 07 sti swap	slava from goshen	Service & Maintenance	15	06-16-2009 03:14 PM
WTB: Transmission to use in my EJ205 swapped GC8	former3g	Tri-State Area Private Classifieds	0	04-18-2009 12:51 PM
Failsafe reverts to "wastegate pressure," so what spring to use in my ext. wastegate?	Wrinkleboi	Water/Methanol Injection, Nitrous & Intercooler Cooling	11	07-09-2006 08:29 AM
need to pic a wiring harness to use in my swap!	jrico023	Subaru Conversions	0	07-16-2005 05:22 AM