|05-14-2009, 09:10 PM||#1|
Join Date: Apr 2009
Chapter/Region: South East
09 WRX MADDAD Gauge Help
I have the 08+ Ultra Basic Boost Gauge from MADDAD and I can't figure out WTH just went wrong...I wired the the gauge as follows...
Red: #3 Door Locks (Instructions say B+)
Orange: #24 Clock (Instructions say Constant Power)
Yellow: ACC #31 or #13
Brown: #14 Lights (Instructions say illumination)
Ground: Bolt to dash subframe
At first the gauge lit up fine, calibrated it and then turned the key to off. I tighten everything up (panels etc) and go to turn it on and the gauge does nothing.
I have tried every imaginable combination of fuse locations and the closest I can get to seeing it light up now is by switching the red and orange where as soon as I turn the key it flickers and then nothing once the cluster,clock, stereo come on.
Anyone have ANY ideas its driving me crazy...I shot Rich at MD an email but I wanted to see if anyone else knows anything.
* Registered users of the site do not see these ads.
|Thread||Thread Starter||Forum||Replies||Last Post|
|WTB: 08-09 AP, Maddad Gauges||bike867||Private 'Wanted' Classifieds||4||08-26-2009 09:37 AM|
|installing maddad gauges help||ShaneInHisRoom||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||2||05-28-2009 02:44 PM|
|2008/09 WRX/STI Gauge Placement||Stuck2Road||Newbies & FAQs||10||03-24-2009 09:31 PM|
|08/09 wrx brake pad help needed||IA Performance||Brakes, Steering & Suspension||2||02-24-2009 03:45 PM|
|2008/09 WRX/STI Gauge Placement||Stuck2Road||Interior & Exterior Modification||3||01-21-2009 12:18 AM|