|05-28-2002, 08:27 PM||#1|
Join Date: Apr 2002
Chapter/Region: W. Canada
Location: Calgary, AB
Boost, Wastegates, Bleed and EGT's
Can someone with some good experience explain to me how the following interact with respect to manifold pressures, back pressures, exhaust flowability and turbo spool up times:
1. boost level
3. Bleed valves
I know this is a bit open-ended but I'm looking to get a back-to-basics walk-through of how all this works. Perhaps you'll just refer me to a textbook which is fine. Just recommend a good one is all I ask. If you choose to take a crack at it then I thank you greatly.
* Registered users of the site do not see these ads.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wastegate Arm and boost creep||jeeps1998||Factory 2.5L Turbo Powertrain (EJ Series Factory 2.5L Turbo)||9||02-10-2007 01:14 PM|
|very Slow boost response, swapped wastegate diaphram and arm!||GregBolby||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||7||07-21-2006 06:21 AM|
|understanding boost, wastegates, and solenoids||boostaddict||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||18||09-12-2003 04:09 PM|
|Upipe and A/F and EGT's||dachoe||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||4||05-28-2002 02:04 AM|
|Wastegate Actuators and Boost Controllers||mynew02||Factory 2.0L Turbo Powertrain (EJ Series Factory 2.0L Turbo)||0||03-20-2002 05:47 PM|