My thoughts for closed-loop to open-loop with link.

Chav · 06-28-2002, 02:10 PM

We can use one of the two drives or both that operate based on rpm and fuel flow to turn on a relay that is normally connecting the signal line from the O2 to the link and switch it to a constant voltage of anywhere from 0-1v based on which voltage is easiest to create. Set the lambda target to this voltage. This way depending on your setting and if it is connected to both drives the ecu will go into open loop at a certain rpm and/or fuel flow.

My other idea (less likely to work):
If we can compress the wideband voltage into 0-1v then we can use it since we can set whatever lambda targets we want (0-1v). From the other posts I've read the resistance of the wideband sensor doest do much and is there just to check the condition of the sensor every once in a while. So all it would take is a device that converts the 0-5v of the wideband with a ratio of 1/5 into a 0-1v. Seem possible?

-Chav

* Registered users of the site do not see these ads.

06-28-2002, 02:10 PM	#1
Chav Scooby Specialist Member#: 3269 Join Date: Dec 2000 Chapter/Region: SCIC Location: San Diego Vehicle: 2001 2.5RS Sedan STM RSTi	My thoughts for closed-loop to open-loop with link. We can use one of the two drives or both that operate based on rpm and fuel flow to turn on a relay that is normally connecting the signal line from the O2 to the link and switch it to a constant voltage of anywhere from 0-1v based on which voltage is easiest to create. Set the lambda target to this voltage. This way depending on your setting and if it is connected to both drives the ecu will go into open loop at a certain rpm and/or fuel flow. My other idea (less likely to work): If we can compress the wideband voltage into 0-1v then we can use it since we can set whatever lambda targets we want (0-1v). From the other posts I've read the resistance of the wideband sensor doest do much and is there just to check the condition of the sensor every once in a while. So all it would take is a device that converts the 0-5v of the wideband with a ratio of 1/5 into a 0-1v. Seem possible? -Chav * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
03 WRX bad cold start idle in closed loop / rich open loop fuelling	toflaherty	Open Source Reflashes	2	04-17-2010 09:06 AM
Close loop to Open loop and vice versa	Walker Lam	Open Source Reflashes	8	01-30-2009 10:51 AM
close to open loop	goixiz	Commercial ECU Reflashes	9	12-29-2006 09:22 PM
Closed Loop to Open Loop Transition, when?	NavyBlueSubaru	UTEC	19	03-03-2006 10:30 PM
What exactly is closed loop vs. open loop fuel control?	Neek	Engine Management & Tuning	5	03-09-2005 12:50 AM