Calling all engineers

seven881 · 07-11-2002, 10:14 PM

I need some help on trying to protype this. I need a picture of the bottom of a GC8 so I can try to estimate if the item below will fit. Also, if there are any other suggestion that would be great.

* Registered users of the site do not see these ads.

Avenger · 07-11-2002, 10:56 PM

What in the world is that supposed to be?

akcel · 07-11-2002, 10:58 PM

hope this helps?

seven881 · 07-11-2002, 11:03 PM

It's an exhaust. That photo is a start, but I need a picture of the bottom when it's on a lift.

Chav · 07-11-2002, 11:13 PM

Sorry I dont have a picture, but your going to have to bend the pipe quite a bit down close to the beginning of the muffler to clear the rear axle. Unless you have something else in mind.

-Chav

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Calling all Engineers	Motts	Car Audio, Video & Security	4	04-26-2006 10:32 PM
Calling all engineers, aerodynamicists, gear heads, and know it alls	bdcz2	General Community	63	07-14-2005 11:44 AM
calling all engine swappers!	sick boy	North West Impreza Club Forum -- NWIC	4	06-19-2005 11:23 PM
Calling all engine gurus	pilfflip	Legacy Forum	27	05-02-2005 10:41 AM
Calling all JDM STI Engine (EJ207) owners!!	sponaugle	Factory 2.0L Turbo Powertrain	11	11-13-2003 03:34 PM

07-11-2002, 10:56 PM	#2
Avenger Scooby Specialist Member#: 1234 Join Date: Apr 2000 Location: Vancouver, Canada Vehicle: 2000	What in the world is that supposed to be?

07-11-2002, 11:03 PM	#4
seven881 Scooby Specialist Member#: 8828 Join Date: Jul 2001 Chapter/Region: MWSOC Location: K-Town Vehicle: 01 BRP 2.2T Hybrid 10 VW Grocery Getter	It's an exhaust. That photo is a start, but I need a picture of the bottom when it's on a lift.

07-11-2002, 11:13 PM	#5
Chav Scooby Specialist Member#: 3269 Join Date: Dec 2000 Chapter/Region: SCIC Location: San Diego Vehicle: 2001 2.5RS Sedan STM RSTi	Sorry I dont have a picture, but your going to have to bend the pipe quite a bit down close to the beginning of the muffler to clear the rear axle. Unless you have something else in mind. -Chav