('93-'01) Anyone Know who sells a straight pipe?

SUBYRS710 · 04-29-2001, 10:17 AM

Hi i was wondering if anybody here knows of any companies that offer a straight pipe from the headers to the exhaust to eliminate the cats. Any suggestions are appreciated, thanx!

* Registered users of the site do not see these ads.

Beefcake · 04-29-2001, 01:18 PM

I'm not sure which companies make a straight pipe the right diameter for a n/a motor. The one's they sell are most likely too big, but you could try taking it to a muffler shop, like a Meineke or someplace. You might have to try a couple places since some might not do it because they could get fined. For an aluminized straight pipe my guess is around $100,not really sure for stainless steel. I'm sure it would help alot if you tell them it's strictly for offroad use and that they put your current exhaust back on after they bend your pipe. You should be able to coerce them to do it.

[This message has been edited by Beefcake (edited April 29, 2001).]

04-29-2001, 10:17 AM	#1
SUBYRS710 Scooby Newbie Member#: 5186 Join Date: Mar 2001 Location: Pittsburgh Pa USA Vehicle: 2000 2.5 RS Coupe Silverthorn	Anyone Know who sells a straight pipe? Hi i was wondering if anybody here knows of any companies that offer a straight pipe from the headers to the exhaust to eliminate the cats. Any suggestions are appreciated, thanx! * Registered users of the site do not see these ads.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
anyone know who sells sti v6 wings?	afstevie68	Interior & Exterior Modification	3	08-29-2005 11:50 PM
Anyone know who sells quaife diffs?	codean	Transmission (AT/MT) & Driveline	3	02-20-2005 03:51 PM
I need a new radiator - anyone know who sells Fluidyne?	AntiochCali	Normally Aspirated with bolt-on Forced Induction Powertrain	1	06-30-2003 01:59 PM
Anyone know whos selling a 99 WRB RS???	VSM EXtasy	Mid Atlantic Impreza Club -- MAIC	9	08-09-2002 01:12 PM
Anyone know who sells Lumbar Pads?	BigElm	General Community	7	11-14-2001 10:31 AM

04-29-2001, 01:18 PM	#2
Beefcake Scooby Newbie Member#: 1824 Join Date: Jul 2000 Location: Livingston, NJ U.S.A.	I'm not sure which companies make a straight pipe the right diameter for a n/a motor. The one's they sell are most likely too big, but you could try taking it to a muffler shop, like a Meineke or someplace. You might have to try a couple places since some might not do it because they could get fined. For an aluminized straight pipe my guess is around $100,not really sure for stainless steel. I'm sure it would help alot if you tell them it's strictly for offroad use and that they put your current exhaust back on after they bend your pipe. You should be able to coerce them to do it. [This message has been edited by Beefcake (edited April 29, 2001).]